Parting Out 2002 Toyota 4Runner SR5 4x4 119,000 miles (Buffalo NY)

[6uam671_T4R]

Pmed

I must be going crazy. I see a notification but don't see any unread PM.

 

[6uam671_T4R]

Pmed

Ok I think I figured it out. I got your PM from the other day. I sent you my contact so you can send me pics. Any luck with the pics?

 

[Deere9798]

Bump. All PMs responded to.

 

[Deere9798]

Bump.

 

[TRD 4RNR]

Thanks [MENTION=170138]Deere9798[/MENTION] for the parts
(and the prompt communication / tracking#, etc.)
Everything arrived in good condition.

Good luck with the rest of the parting out project.

 

[Deere9798]

Thanks [MENTION=170138]Deere9798[/MENTION] for the parts
(and the prompt communication / tracking#, etc.)
Everything arrived in good condition.

Good luck with the rest of the parting out project.

Thanks for the feedback. I really appreciate it.
_Charlie

 

[Topgun15v]

Hi Charlie,

If still available, I would like the cigarette lighter and housing. Below is a picture of what I am looking for. Right now I just have a blank hole in mine so I would need both the outside metal trim and the inside housing and the lighter portion. Please let me know and also final cost. I am zip 75071 Mckinney, TX. Thanks, Ryan

 

[Topgun15v]

I also forgot a few things!

I saw someone interested in your rubber trim on all 4 doors. If still available, I am looking for just the rear tailgate Rubber Door seal trim.

Also, there is a little white piece that holds the hood latch/bar (bar used to keep the hood open) in place when in the down position. I could use that little white clip piece as mine cracked in half.

Also, on the driver side sun-visor there should be a plastic cylinder which is what snaps into the clip on the headliner. All I need is this plastic cylinder piece which attaches to the actual sun-visor.

Let me know your thoughts on these. Thanks

 

[Deere9798]

I also forgot a few things!

I saw someone interested in your rubber trim on all 4 doors. If still available, I am looking for just the rear tailgate Rubber Door seal trim.

Also, there is a little white piece that holds the hood latch/bar (bar used to keep the hood open) in place when in the down position. I could use that little white clip piece as mine cracked in half.

Also, on the driver side sun-visor there should be a plastic cylinder which is what snaps into the clip on the headliner. All I need is this plastic cylinder piece which attaches to the actual sun-visor.

Let me know your thoughts on these. Thanks

Hi Ryan, actually the entire dash piece was sold as a unit. Also, all of the seals including the trunk seal have been sold. I do still have the plastic prop clip and the sun visors. I would prefer to sell the entire visor.

Thanks,
Charlie

 

[Topgun15v]

Hi Ryan, actually the entire dash piece was sold as a unit. Also, all of the seals including the trunk seal have been sold. I do still have the plastic prop clip and the sun visors. I would prefer to sell the entire visor.

Thanks,
Charlie

Charlie,

Thanks. I would buy the entire visor but I have the Oak/Brown color in mine. How much would you want for the entire visor? If cheap enough I may just do it and throw the visor out =). Thanks, Ryan

 

[ivopivo]

Do you have the rear hatch shocks?

 

[Deere9798]

Do you have the rear hatch shocks?

I do, but they are not terribly effective in supporting the rear hatch.

_Charlie

 

[CRB Racing]

PM sent.

 

[aleksgain]

Interested in the roof rack.. How much for the whole thing shipped to 02148?

 

[rditto]

Does this truck have ABS?

How much for the a rear axle shaft, bearing, drum brake assembly, and dust shield? Basically everything that comes out attached to the rear axle shaft.

Shipped to 75701

Thanks

Russell

 

[4runnerEsQ]

How much for the ABS brake master cylcinder pump controller?

 

[Deere9798]

Does this truck have ABS?

How much for the a rear axle shaft, bearing, drum brake assembly, and dust shield? Basically everything that comes out attached to the rear axle shaft.

Shipped to 75701

Thanks

Russell

Would you be interested in the entire axle? Also shipping is going to be very expensive...

Thanks,
Charlie

 

[thezentree]

Are the front door armrests spoken for? How about the top cover of the steering column?

 

[Deere9798]

Bump.

 

[hartychr]

Any chance you have the plastic front seat track/end covers in tan? Need both passenger and driver side. Thanks!