Recent content by 1stgenfan

request sent islander here

OME lift kit is currently on its way to my local ARB dealer looking to grab some 33's befor i install anyone with 33x10.5r15 tires or any 33's on rims I'm located in BC, canada. but willing to travel within canada or down to WA,OR or ID for pickup

i just did this a few weeks back and gotta say i love the finished product i used a wire cup on an angle grinder to rough up the surface for better adhesion of the spray in liner. this also cleaned up rust and some nastier bits. then i sprayed it out with an air nozzle and used a can of brake...

hey im in the middle of pulling my V6 from an 1989. how the hell did you get the top 2 engine/trans bolts ? i was seriously contemplating pulling the trans too out of frustration but decided to wait and post on here anyone ?

should be located along the fuel rail on the passenger side of vehicle. near your t-case. you'll need a 14mm wrench for the line fittings and something bigger to hold the feul filter i think its a 18 or 19 maybe... once those are off just a couple bolts holding the shielding on.. and viola...

thank you so much for the timely response. ive been missing that back window

is this the centre bolt on the ceiling that has the censor ? if not which bolt hole has the sensor ? I only have 4 bolts for my canopy and this perfectly describes the problem im having. it worked when i took it off and now wont go back up with the canopy on. and ive made sure the wiper was at...

I've done the searching on site and google. no help there So i have a no start. ECU is fried. im getting good compression but no feul and no spark. i know because its EFI the no feul if from the ECU being burnt because it was working fine before. now my question to you. the no spark. would a...

sorry for ressurecting a dead thread, but i have 2 spare tailgate weather strips, if your still in need. live in BC canada

Need an ECU for 1st gen v6 4x4 part number 89661-35280 or peg arrangment 10p 18p 24p

hmmm the one i need is a little different. unfortunatly my normal guy didnt have the right one. i need the 89661-35280 or pegs are 10p 18p 24p if anyone has one lying around or a parts truck it would be appreciated. i will post an add in the classifieds

thanks so much. saved me a tonne of hassle knowing i can only use a 1st gen runner or 2nd gen truck

not exactly sure of the differences between 87 and 93 but there was a generation gap in there. Some of the newer 22res have different sensor possitions. you should be able to use the old harness but may need to extend a few connectors for sensors. most should just snap right on tho. if your not...

well. I'll admit something that nobody should ever have to admit. I hooked a battery up backwards. I wont make excuses it was just a dumb move. So i popped my nice big 80A fuse. replaced it. found some burnt wire coming off the positive terminal. replaced it. Alternator is toast. replaced it...

Back with a whole new beast. Rolled the old one about a year or so and been off the site since. but just yesterday i found this doozie on local classified and just had to bite. 1989 black (half decent paint by PO) sr5 v6 headgaskets shot and the tranny is leaking a little, probably get a whole...