Recent content by 2runnersnyynyg

80views, NOTHING? lol

Has anyone used a voltage booster on a 3rd gen and had a good result after installing an AGM battery. I drive a lot of small trips and usually do some longer drives on the weekends, my dilemma is that the small trips are making so I can only get get 1 start after a drive. if the car runs after...

I have the TRD FJ wheels in 16’s love the look, I have the tundra big brake with these wheels and use the spider track spacer. Not sure that I need the spacer but I was using when made the conversion.

Are you getting codes? Check engine light? I’ve seen failing injectors cause a stall once high idle goes down after start up. Would suck to have to do just after purchase but with nearly 200k can’t be ruled out.

SOLD! Will update when complete

outside of bicycles and coolers for the beach(chairs etc.) not a ton of rear weight, maybe a solid rear bumper down the road just measured I'm at 23 3/4 in the rear with 906 OME and 21 1/2 in the front on the factory 4runner tall spring measured from hub center

I was on board with the lowest perch scenario but the TOYTEC guy was saying he didn’t recommend, no warranty, yada yada and I wanted to feel out the community

It was put in a while back with the 4Runner talls and I had to use a 1.5 spacer in the rear to level, had a rear wheel bearing take out the axle and order a set of the 906’s to eliminate the spacer. Has a bit more rake at the moment than I’d like. Picture not gonna do much justice. I think the...

Which I’m ok with and understand I’d have to keep on lower perch. The toytec guy seemed to not want anything to do with this setup and I just wanted to feel out the crowd so to speak. He said coils break and shocks break and OME won’t warranty or bilstein. Let me know if you do it and how you...

So I inquired with Toytec today about 5100’s and 880’s due to the website saying only to be used with OME nitrocharger shocks. They(He) said there have been a lot of failures with the 5100’s and the OME springs and they don’t recommend. Can I get some feedback from someone who has done this...

Whoever figured this out should be collecting a vig from the amazon store capitalizing of his research, installed last night and I almost want to drive it just to spray the windshield. If this has been a noted weak point for you don’t hesitate. This should be added to the knowledge page for...

It may have to be a master, the valet is just slightly different at the very bottom,(doesn’t have a little bump out) you may need a master to operate I will try to confirm.

Could the pos. Camber be from bushings ? That seems to be somewhat odd that a lower arm would have that much impact on pos. Camber but I’m am at the point where I’ve spent lots recently to have this truck for years to come and I am really at wits end. I am willing to get the spc uppers and even...

So, i happen to work at a dealer(different brand) and have had the alignment done by the shop installin the the suspension part(freinds mechanical) and note that the in addition the lower control arms were replaced as well. car tracks straight it just feels like im running on the edges. feels...

So the alignment is adjusted within factory alignment spec but when standing in front of the car there is noticeable positive camber, i feel like the wheels arent making great contact with the ground in turns as is it is just riding on the edge where i get tire noise even while braking into a...