Recent content by 4runn34

Just my 2 cents but the bottom crank looks off a tooth. Also are you sure you put back the crank position sensor gear correctly?

To add some more content, the used door came with the window and actuator already installed. I pulled the harness off my old door and installed it on the new door. Could it be the actuator on the used door is different? The plug from my harness matched up.

I purchased a passenger door on ebay that matched my 2013 4runner color. The people I bought it from asked for the vin to make sure it matched. Everything seemed good. Installed the door, everything works except when I'm sitting in the drivers seat the passenger window button won't operate...

I took my 4runner to get the AC fixed earlier this summer. The mechanic after looking at it said the "blend door actuator" was missing so I can't switch from heat to AC. He said to come back later in the fall to get the heat turned on. Well I would rather just source this part and install it...

Does anyone have one of these cool rear spoilers from Burtman Industries? Was it difficult to install? Would say it's worth the $400? Burtman Industries[0090]=6417468762&opt[3632]=8191299688

I accidentally threw out the aluminum mounting brackets for the radio. Anyone know where I can order another set of brackets?

Thank you! Going to try this, this weekend. Tried last weekend with the Lisle Seal Puller but couldn't get the seal out. I went to harbor freight and purchased a slide hammer that I'll try this weekend. Figured out they call it a CV axle seal not an axle gasket also. No wonder I couldn't...

I bought it used so not sure. I drove it 40k in 2 years. Should have changed that immediately. Lesson learned. I love 4runners and will for sure have more in the future and will do that maintenance as soon as I get one. :moping:

I suffered the LBJ failure a few weeks ago. I went to replace the CV axle and now where the CV axle goes into the diff now leaks fluid. Just a few drops a day but I would like to replace the diff gasket. Does anyone know a good write up to replace the diff gasket? I've searched the site and...

I went out at lunch and got underneath and found the top caliper bolt was missing. So I walked back about 200 yards and found it laying on the road. Torqueing to spec is not enough apparently. When I get home I'll put loctite on all of them. I couldn't imagine having that happen at highway...

Driving to work today I had the right front wheel lock up just as I was braking to pull into the parking lot. I did the Tundra Brake Upgrade a couple months ago so it seems odd the brake caliper would go bad after 2 months. Could it be something with the CV or something else? I'm planning on...

Which SC are you running?

I ordered the Bilstein 5100's for the front end on my 4WD, moog coil springs, and mevotech strut mounts. The Bilstein's didn't come with bushings or washers. Just the shock, dust cover and nut. The Movetech strut mounts look like they have a thick bushing built in. Do I need to order strut...

Are you thinking about an LS swap? Just curious based on your name. I've considered putting a 5.3L (even stroking it to a 5.7L) in my '99 just for fun.

Just started using Amazon Basics 5W-30.