Recent content by 94stick

Well I can rule out the catalytic converter. I removed it and it looked fine, car still doesn't want to start even with the cat removed. Any ideas? Thanks for the reply, fo' runnin'...

Hey what's up everyone, Suddenly my 94 4runner 3.0 has some issues: - When not completely cold it will only start if I floor the gas pedal. It will crank and crank but won't turn over unless I floor it. - After getting it started it runs just fine, no hesitation, no power loss. It does idle...

Like the title says, looking for a good condition 5spd 4x4 shifter boot. Brown or Black if available, I'm not sure they made a black interior but if you've got one I'll take it. Thanks!

Nevermind, mods please close. Easy as pie...

What's up guys? So like the title says, I installed some Pro Comp lights on my 94. They look great and work exactly as I wanted them to. However, during the install I believe I managed to short or unplug something for the climate control lights. I had most of the dash off of the passenger side...

CV axles will be ordered in a couple of weeks. In the meantime I've got a set of Procomp Explorer 55's that just came in with a relay kit to be installed, I've got a new antenna mast to set in and found a couple replacement washer fluid pumps in the junkyard today. The truck is driving great...

If they are both 3.0's then go with the 2nd. Also, IMO the 2nd gens feel like they have a bit more room inside for tall guys like myself.

Well, there was a bit of mis-communication. I took it back into the shop to get the Timing belt and water pump serviced while I was at work, and learned that he didn't do the CV axles because he thought I told him not to. Looking at the receipt from earlier service, it didn't say anything about...

Oh yea, can anybody give me a part number for the gasket that seals the pre-cat exhaust pipe to the manifold? I can't tell if it's a ring that is held between the manifold and pipe or if it's a "triangle" with bolt holes that is bolted between the two...

Thanks, yea my dad had a 2nd gen when I was in high school that I drove around a little bit. Now that I think about it I remember the ticking sound on that one too. Worked on her a bit today, the exhaust pipe to exhaust manifold connection was a little loose so I tightened it up until I can get...

That's somewhat relieving. I had planned on getting all the fluids changed this weekend as mentioned previously, but time constraints and remembering that I know a very good mechanic who "cut his teeth on 4runners" led me to take it to him to do it. While there I asked him to look the thing all...

PM'd

Easy enough! After that I'm taking her to a great 4runner doctor around here to give her a look over / physical, lol.

Ok, so I've searched and searched. I downloaded the FSM and still couldn't find it. Maybe I'm blind: I'm planning on changing out all the fluids on this thing this weekend and I can't find CRAP on fluid specs. I found some things, but nothing on QTY. Can somebody fill me in? Transmission...

ALSO: According to Toyota's owner website the head gasket recall wasn't performed! What are the chances of honoring the recall if the head gasket ever goes out on this thing, lol.