Recent content by 97_Runner

Part 3... Sweet, let's solder it up... And I immediately set my soldering iron down into the plastic wire strippers - destroying the tip. I fiddled with it for about an hour trying to get it to work, until I just tossed it and crimped the wires instead. So for anyone who says speakers...

Part 2.. There was this annoying little gap that I hadn't noticed - basically the plastic blank below was warped, I assume from the factory. So I took a block plane and just jointed that top edge to eliminate the gap. Then off to markup. Probably the main reason I wanted to go this...

TLDR: Analog'ish in a digital world... --- Obviously car audio is a massive rabbit hole. There are a thousand different ways one could go, and up until I guess last week, I was content to leave the system in this 4runner that I've had for over twenty years, basically the same as it's been...

In my opinion you don't have to look much further than two of the members on this forum. One is blcktpgsr. He modded a stock ARB bumber and made it into one of the best looking bumpers you can find on a 4Runner: And then he went ahead and made one of the best looking rear bumpers: The...

This site has been a pretty invaluable resource to me. I wanted to try and contribute some information that I haven't been able to find here. I have a 1997 4Runner Limited with the factory elocker. Like several people, I had issues with the status light continually blinking - which is supposed...

I just wanted to say thanks so much for this write up. It helped enormously. I don't think it's necessary to pop off the tweeter, or at least it wasn't for me. Would also recommend wrapping the end of your flathead screwdriver with electric tape before prying the door off - it's a little easier...

Is it just the LBJs that are recommended maintenance for high mileage 4Runners, or LBJs + OTRE, or LBJs + OTRE + ITRE?

Is it safe to say this isn't happening?