Recent content by Androo

I forgot to mention, I have the MT 2inch lift coils in the rear.

Hey all, I was curious if anyone is running the fox 2.5 rears with 2in or even 3in lift coils in the back? Reason I’m asking is, the only 2.5 fox offers seems to suggest (0-1.5in lift). I don’t do serious off-roading but my county road is rarely maintained and washboards badly. Would I still be...

Hey everyone, I think my alternator has gone bad in a grocery store parking lot…, the battery light has come on and there’s a terrible squealing/squelching noise. However, when I look at the belt, it’s still on all the pulleys but the pulleys aren’t turning. That includes all the visible belts...

You’re right, I was under the impression it was free shipping… I guess I’m going to buy an already refurbished motor just for a straight swap. I could do the repair I believe but I’m not sure how long it would take to do proper clean and replace and I need vehicle soon.

Oops, my bad haha. 2003 -2005 TOYOTA 4RUNNER LEXUS GX470 ABS Brake booster Pump motor REPAIR KIT | eBay

Hey everyone, So my abs/ brake light came on along with the constant beep sound… I’ve determined with the key in the on position, the pump doesn’t come on (when pressing the brakes). After banging on the pump a few times it does try and come on but subsequently goes off. Long story short, I...

As everyone has mentioned already, there will be increased “stiffness” but that doesn’t mean bad. I have OME 886 (heavy) w/the firm valved nitrocharger shock. With a v/8 and a bumper w/ no winch, I found the ride to be perfect. I recall old pot holes I’d hit and bounce around on my morning...

I do have a front bumper but I’ve had it since the install so not newly added. The more I think in this the more I think I’m over thinking it. I’m pretty sure these coils have to be good still..

Hey everyone, So I’ve had OME nitrocharger struts w/886 coils for about 3 years now. They’ve been great for me! Lately however, the front end has been less than stellar and I believe the shock absorbers have went bad(lost their nitrogen charge). No biggie as I’m planing to try these new fox 2.0...

Thanks guys for the posts! After some more searching I found an expanded diagram of the rear suspension and found my part number! 90119-14119 and it’s referred to as a lateral bolt for anyone wanting to know. Probably why I couldn’t find it searching under “rear LCA bolt.”

Hey everyone, My rear LCA bolt is stripped and just spins freely. I haven’t had time to pull the other side out but figure I need to buy a new bolt regardless. My question is I can’t seem to find a part number or anything about that particular bolt. Does anyone know of a part number or what...

Would you be willing to split up into pairs? I only need a set for the rear

It’s a 2004 v8 4wd. So your part should be the same eh? I’ll pm you

Hey all, I had a friend of mine weld an eimkeith PCK on, and unfortunately he let the brake line that is mounted on the axle touch the bracket too soon and so it kinda melted. But now it seems the bracket kind of rubs against the brake line itself.. I’m going to have him grind a little off that...

Hey everyone, I know this horse has been beat to mush by now and I have done my research but I just need a quick clarification. I have new rear rotors and brake pads, however my caliper has seized. So with that, is all I need for this swap the 10-15’ rear calipers? Since my pads an rotors are...