Recent content by artstar1983

I have found a body shop that will cut out the rust in the rear wheel well. They will weld in replacement metal and fiberglass and cover over with undercoating. While I had the trim pieces out I put a endoscope into the holes to examine the inside of the rockers. They had moderate rust from...

Thanks very much for the info, that makes sense. I have not seen an issue like this before. I am in the rust belt so expect I have my work cut out for me finding a body shop that will look at this.

Thanks for the response. Any ideas as to where the rust is coming from? This does not appear to be a common rust area.

Hello All, I have a 3rd gen with rust in the rear passenger side. Not sure where it is coming from. Looking for some feedback on whether or not this can be cut out or if I should just put some POR 15 for Eastwood rust converter on it and call it a day. The truck is in very good condition outside...

Yes, I confirmed that it isn't just the light not working. The light illuminates and devices (cell phone for example) receive power when the truck is in Park. However, as soon as I shift it into Drive the 100/120W light goes off and the device stops receiving power.

No, the problem is that the 100/120W power switches off as soon as I put the 4Runner in drive. It works only while in park.

Hello folks, I am having trouble with the 120V power not functioning on my 2010 4Runner. Both the 120/100V and 400W power modes work when the truck in running and in Park (both lights are illuminated on the button below the steering wheel). However, when I put the truck in Drive, the 120/100V...

Getting ready to replace front pads on my 2010 SR5. With other cars I have typically bled the brake lines while compressing the piston in the caliper. However, I don't have the equipment presently to do this on the SR5. I have not been able to find any specific feedback online regarding...

Hello folks, I have a 2010 4Runner purchased new with about 75K miles. It exhibits the transmission shifting issues with speeds below 50MPH that I believe would be addressed with TSB 0166-10 (mentioned in many places on this forum). The truck is long-since out of it's warranty period. However...

Hello everyone, I have a 2010 SR5 that I am having the following issues with. I was hoping someone could tell me if they are experiencing these issues as well. First, after I am sitting at a red light with my foot on the brake and I lift my foot off of the brake to hit the gas the transmission...

Hello, I took delivery of a 2010 SR5 in September. The truck shipped without floor mats. The dealer that I purchased it from had a Limited on the lot and pulled the floor mats out of it and put them in my car. The dealer told me that there are the same floor mats regardless of the model. I...