Recent content by Awdtsi42o

Thank you very much for the quick reply, Would the issue your talking about cause the issue to happen only when it is extremely cold out after the car has warmed up? What I am trying to say is the truck does not do it all the time, only does it when it is really cold out after the truck is...

Hey guys, Happy New Year! I live in New England and recently the temperatures have gotten pretty cold. In the past few days I have noticed that after the truck has warmed up, the idle is very unstable. The idle goes down a little below 1000 RPM, where it usually stays when idling properly...

Thanks for all of the information and support, really means alot to me. I am located in Mass, I would be willing to drive anywhere in the New England area if there was a member who would be willing to help out with project, if they have a welder and ripple to fabricate the part, that would be...

Hey guys, Thank you very much for all of the replies, I appreciate that. I have access to a welder that I would be able to use if I attempt this project by myself I have done minor welding in the past but I could practice before actually attempting this repair. What would be the procedure to...

Bummer What a bummer... I thought the same thing when I first looked at it but I was hoping that I was wrong and it wasn't something major. Anyway, how dangerous is it to drive like this? There is no other noise besides the clunking of this being loose. If I avoid bumps and take it slow can...

Pictures Pictures, hopefully this works :o)_

Hey guys, I have had my Toyota 4Runner for a total of 3 weeks and so far it's been great, it's an awesome vehicle and I have a ton of fun driving it, it is a very good purchase. Overall, as I mentioned before I am very happy, however in the past 2 days I started hearing a clunking noise coming...

I'm sorry, I will get some pictures immediately and post them as soon as possbile. Thank you for taking a look at my thread. Sorry about that. Erick

Hey guys, Thank you very much for all of your replies and all of the information. I have to go under the truck and look and see exactly what I am dealing with. I have some fabrication skills and I'm very mechanically inclined, I have been working on cars most of my life. I really appreciate...

Can anyone shed some light on my situation, I am trying to repair the brakes ASAP. I would like to have a bit more information before I proceed. This is my plan: Running one line from the master cylinder to the proportioning valve to the rear of the car to that rubber line near the...

Brake line questions... Hey guys, I replaced 4 sections of brake line on the two lines that run from the master cylinder to the rear LSPV. As soon as we started to bleed/ pump the brakes, another line is leaking that comes right out of the LSPV it goes to a rubber line near the differential...

Guys, Thank you so much for all of your replies and all the great information! This forum and community seems like an awesome place to be, I am very grateful that I am a member. I have not tested the 4 drive system on my 4 Runner yet but I was told it worked fine when I bought the vehicle. I...

Hey guys, Just purchased a 92' 2.4L 4WD with a manual transmission. I have a few questions, was hoping you guys could offer some advice: 1) The lighting for the heater/AC control is not working. Not a really big deal but if anyone knows how to replace the bulb that would be great. 2) When I...

Hey guys, Yesterday I purchased a 1992 Toyota 4 Runner. I am very happy with my purchase but upon inspection underneath the car I noticed that the drivers side shock was loose and hanging there. After looking into why the shock wasn't fastened at the top, I realized that the rear drivers side...

Hey guys, I repaired the brake line section that was rusted out and leaking yesterday. However, after repairing the section of line that was rusted out, an additional line blew out while trying to bleed the brake system. I am at the point that I think it is better to replace all of the brake...