Recent content by BooRad06

Checked all email boxes. Don't see anything.

Instructions for Slyfox module I purchased and installed this module about 3 years ago and it worked flawlessly. Unfortunately, some ass hat blew through a stop sign and totalled my 4runner (which I recently replaced with another V8) . I was able to save the module and wiring, but in my haste...

Just sold locally. Sorry.

I don't have Weathertech rears, since my back seats are folded down 95% of the time. Just some all-season mats that fit nicely and a gray Husky cargo liner from my previous 4runner. I'd take $75 for the fronts. I'm in Kansas City. Not sure what shipping would be.

Weathertech front mats, black I have a set of fronts. Black. 2 years old, but in excellent condition. Would have to ship, though.

So the seller sent me 2 blanks immediately after notifying him. They arrived 12 days later. Took one to get cut. Popped the pin out of the fob that holds the key in place, dropped in the new key, good as new. Still satisfied, especially after the seller didn't BS and shipped new blanks right away.

His eBay profile says he is away until the 16th. I sent him a message, so we'll see if I get any response. He is very highly rated, so I'm hoping to get at least a replacement.

Update So..... 8 months later and here we are. Snapped while turning the Runner OFF this morning. Thankfully there was enough of the key sticking out of the ignition to pull out easily.

Finally got rid of those piece of sh1t GY Armortracs. Replaced with 255/70/18 Duratracs.

So after a trip to Lowe's, fail, cuz Old Man River couldn't figure out how to get the key in the cutter. And at that point I didn't trust him. Then it was off to Ace Hardware, fail, cuz the fine gentlemen didn't know what my key was made of. My day ended there as I had prior obligations. Today I...

Mine just arrived. Off to go have it cut and then I will be programming it.

So did resealing the coolant manifold with RTV solve your coolant leak issue? Were there any other parts/O-rings needed for this?

http://www.toyota-4runner.org/4th-gen-t4rs/149699-headlight-restoration.html http://www.youtube.com/watch?v=QCHCihzu-QI The kid in the youtube link is a goober, so no need to pay close attention to him. I used 800, 1000, and 2000 grits to wet sand mine. Clean covers with isopropyl alcohol...

Headlights were looking pretty bad. Restored with wet/dry sanding and Spar Urethane method. Lasted well over 18 months last time.

DIY lowering bracket I did the same thing. Had the angle irons sitting around and just trimmed the top down a bit. Used some 1/2 PVC spacers and original rack bolts. Only thing I didn't have were the stainless U-bolts. Entire thing cost me like $12.