Recent content by Brian Keeler

New meats! New KM2's under new lift

OK, got it! Lift is SOLD

If that link doesn't work try this one http://blacksport4runner.shutterfly.com/

Took the lift off last night here is the pic of what you get. Everything you need just need to reuse the bottom bolts on the rear shocks on your vehicle. Easy to install has directions and the tags are still on telling you which side...

Here are some more pix of the truck so you can see the "stance" and no sag of the lift. http://blacksport4runner.shutterfly.com/pictures#4Runner planning to remove the lift kit and install new one assuming I get the new one by then and the weather is good!

It is the whole lift kit including shocks and hardware

I am going with a bigger lift so selling the lift that is currently on the truck. This lift was on the truck when I bought it and from what I can tell has maybe 40K miles on it. No sag and firm ride. Provides 1" front and 2" rear lift. Will have pix of lift when removed this weekend. If...

Looks nice SnowRambler! RicMan- If you have a good drill and a cutoff wheel it is a piece of cake. Only about 8 bolts to remove old bumper. Then use a cut off wheel to cut the plate off the frame. Use a flap wheel to smooth then hit it with some paint. What I did was fit the bumper on the...

How tall in inches are those 255's? Looking good!

The steering shaft has an adjustment on each end, one on the inside of the vehicle at the base of the steering wheel shaft and one below the rag joint. I had this same problem and couldn't get the shaft to extend long enought. Some people use washers as spacer at the rag joint but I used this...

Many thanks for the info!! But I don't really have to disable my DRL's right? I don't care if the fog lights won't work if the DRL are on.

OK, I hooked up 55W Halogen's with the factory fog light wiring and now what to keep lights on when in high beam for off road use. Should I wire seperately to avoid overloading the circuit? Or is there an easy way to disable the feature that cuts power to fog lights when hi beam turned on...

Here are a few

To get ready you can go ahead and cut the stock plate at the end of the frame. Don't cut the plate off but cut the plate the size of the end of the frame as the bumper slides over the frame. I slid the bumper on to where the stock bumper side mounts matched up to the mounts on the ODL bumper...

Done up to 154 My ODL front bumper is in need of this winch!:bluejump: