Recent content by c310sar

no one? jerks.

Hey guys, so my rear shocks are just about done. The 4runner bounces way too much from the rear and I'm looking to fix this issue. There is also a noticeably known sag leaning in the rear. I have a 2.5 spacer lift (I was young and broke and went the cheap route) and was wondering what shocks...

This makes sense. Thank you. Given it turns on when it touches the frame, it does turn on so this makes sense thanks again I'll do that and go from there

:ybrick: hey guys, need some help figuring out what the hell is up with my driver side fog light. the 6+ years ive owned my truck its never stayed on, and as a matter of fact, it is loose and basically dangling. If I put my hand up the front bumper and lift the light housing, it stays on, but...

Lol I ended up taking the time to insert the positive end back into the connector and soldering it. Havent had a misfire or problem in general yet.

This. Thanks mate. The red and black are what snapped out of that connector. I'm wondering if I buy these if I would have to solder it since there is no other way around it

Here is a pic of the plugs.

The red/blue is the positive cable and and the grey one is negative and they belong inside the connector that's next to them in my hand. I didnt think of that, going junkyard and the whole resoldering. I did manage to push both back in but I feel eventually theyll pop off again -__-

The red/blue is the positive cable and and the grey one is negative and they belong inside the connector that's next to them in my hand. I didnt think of that, going junkyard and the whole resoldering. I did manage to push both back in but I feel eventually theyll pop off again -__-

More pics. The 4runner starts up fine but I feel this will leave me stranded eventually after it becomes loose after a while. In one picture you can see the other ignition coil with this wire hooked up to it as normal

Was changing out my plugs when I accidentally ripped an ignition coil wire right off the Male input that hooks up to the ignition coil itself. If you check out the pictures itll make more sense. Long story short, I managed to push those two wires back into the Male plug (2 wires positive and...

you might be right on that one.. I don't think the rear coils have ever been changed. The shocks have, but not the coils. I might look into swapping them out.

lol whoa. what a difference. much better

I went with the daystar 2.5 lift on mine bud.. this was about a year ago now. when i first did it, my mechanic tried to advice me to change out the rear shocks before installing the lift due to lack of length. I still installed it without the rear shocks being replaced and it came out fine. The...

thats hilarous. It was time for me to finally get rid of it after 2+ years of it being there lol