Recent content by calimero

Thanks Kevin, Checking them out

Hi all, I am looking for the usual recovery gear: - D-ring shackles - snatch block - tree saver - winch damper. Would any of you have a recommendation for a good US brand that has served them well? I have found by browsing online GearAmerica but have no idea if it is any good (seems so). Thanks...

Thanks MAST4R and RageAndLove for your quick reply. I know that the RCI aluminum is not the best option but should be sufficient for me. I have had the RCI front section for more than a year and despite it being Alu instead of Steel, it has held up quite well. As I do not want to change my...

I have a 4runner TRDpro 2017 and am going to replace the gas tank OEM skid plate by the RCI aluminums version. While I see no issue in installing the RCI without lifting the vehicle, I wonder if it is possible to take out the OEM without lifting the 4runner because of the attached links. Anybody...

Bump! So anybody has this tray with the ARB compressor?

It's the CKMA12. What ARB calls the High Performance 12V on-board compressor. It is also sold in a carrying box like the one in the photo above.

Does anybody have that specific powertray with the ARB compressor installed on? - Is there enough clearance under the hood to put in the T junction with the quick disconnect and the pressure switch? The photo on the website seems to be using additional pressure hose and connectors to attach the...

Ignition wire connection I just received my SP9100 and waiting for the ARB power tray (the only available right now) as I also want to attach the single ARB compressor. I am still kind of suspicious about the compressor and its vibrations being on the same board as the electronics... will...

Cymon, one last question. Do you remember how much torque did you use on the bolts? Thanks

Torque Does anybody remember what torque was used on the skid plates bolts? Thanks

I see. reduced spaghetti. I am guessing that if you have a compressor, it is directly connected to the battery (or + and - from the fuse box) as the fuse box 6 connections do not seem to handle more than 30amp. Is there a fuse between the switch-pro and the battery or more precisely between the...

I have some switches at this location already. Where did you relocate them (if youhad them in the first place)? Apparently the SDHQ also has an OEM top part (where the mirror switches are) with a cutout at the top to fit in the remote.

This is indeed the nice way to install. What are you using the left fuse box for?

How is the board and the electronic of the switch-pro handling the vibration of the compressor? I am guessing that a bit of blue loctite may help in keeping the blue sea connectors in place. I do not have my compressor yet but think that this generate a fair amount of vibrations.

What mount will you be using and where will you place it? Personally, I will be making myself a shelf like the one of power trays with Blue Sea connectors to make things simple and clean. Keep us posted on your install and give us a quick review. Thanks