Recent content by Cow_doc.308

Thanks. That's exactly what I needed Sent from my iPhone using Tapatalk

Anyone know what size bolt is needed on the axle end of the panhard bar? I noticed this morning that mine is MIA. I'm guessing that it didn't get tightened good with the lift went on. I need a new one ASAP. I'm hoping its something I can pick up at Lowe's or HD. Anyone know the size before I...

I replaced master and slave cylinders for the clutch and all problems resolved. I'm not sure which was the culprit as I didn't test in between but that fixed it.

Got my rig back from the mechanic yesterday. Toytec/Eibach up front. Drove it home and drove it around the block today. Noticed a very small amount of grease has seeped out around the inside boots on both axles. Is there something I need to do? Or just get ready to reboot or replace axles?

Slightly better side view. Still haven't seen this in good daylight other than the above picture. New batter going in tomorrow and alignment ASAP.

Thanks! 228 or 229. I don't drive it often for the last year. Planning to start driving it more. Oh yea, bought a new battery today to put in it.

Well this took a lot longer than plan but a lot happened at once this week. Toytec/Eibach and Tundra Bilsteins up front, LC coils and shocks out back, new steering rack, inner/out tie rods, LBJs, wheel spacers, BudBilt front skid, diff drop installed by my mechanic. My guy hooks me up big...

shoot me a PM I have an extra set. I can send you one.

I'm just passing it along. Based off this thread they seem to work. And that's cheaper that any LR parts i've found. http://www.toyota-4runner.org/3rd-gen-t4rs/188846-ebay-upper-control-arm.htmlhttp://www.toyota-4runner.org/3rd-gen-t4rs/188846-ebay-upper-control-arm.html

Since I saw the post about the ebay UCA's I've been sort of stalking the seller to see if they came back into stock. THEY'RE BACK! 1996 2002 4 Runner 4WD Steel Full Lift Kit Front 2 5" Rear 1 5" | eBay selling it as a 'lift kit' but you could trash the other parts and have less in a set of...

Dropped mine off at the shop. Toytec springs and 5100's going up front. LC coils in the rear. New LBJ, ITR, OTR, and possibly new steering rack going in as well. And 1.25" wheel spacers.

Found this on Amazon. Anyone used it? Seems like a decent kit. https://www.amazon.com/FRONT-Calipers-Rotors-Ceramic-Performance/dp/B00EOBMFAY/ref=pd_sim_sbs_263_2?ie=UTF8&dpID=51gpY5NwzrL&dpSrc=sims&preST=_AC_UL160_SR160%2C160_&psc=1&refRID=B925VF02H8T26WZRND9A

I use a 3/8" extension and ratchet. I think the extension is 16 or 18 inches long. Bought it at Autozone I think

I'm going to update this just in case someone finds it in a search in the future. I replaced the clutch master and slave cylinders today. Pretty easy job. Probably took me an hour maybe 1.5. Cound be done much faster if I did it again. Access to the master cylinder is the hardest part. Also...

Replace clutch master and slave cylinders. Fairly easy job. Access to master is tight but doable without removing any other parts. Changed the oil too. I think she'll pass state inspection now :)