Recent content by CWccw

The creater of the only one on thingiverse is a member on here, but those were posted 2 years ago. I dont even know if they are a 4runner owner still. The stl's are way too small to make anything useful. 1.81mm across? lol that doesnt work! Does anyone have any alternatives?

Great to know, thanks! Trans is running strong but sometimes it wont downshift when cold. Very likely it needs a flush.

I did this on a 160k mile 98 blazer and the trans crapped out. Is that going to happen on my 317k mile truck? What should I know specific to the 4runner when changing trans fluid? This is for the auto

Mine was held up on something, I got it out. That was driving me nuts!

Im putting a 2001 hatch on my 98. How do I remove the window regulator so I can remove the rest of the harness? I can’t find a single FSM, which is weird, and alldata doesn’t offer any information anymore (goodbye 20 dollars). No videos exist either. :/ The hatch isn’t on the car and the window...

This mount on my truck doesn’t connect to anything. It’s just bolted to the car and wobbles in free space not securing anything. Should there be something else this goes to?

So just a road test will cause these issues? I had trouble in sand at the beach too if that makes any difference.

When I shift from 4wd to 2wd it wont shift all the way, feels like it’s hitting something before it can shift all the way out. If I hit a bump it will shift out. Sometimes I have to drive in a left hand circle to get it to pop back into 2wd. What should I start checking?

Going on a 98. Im trying to do this as minimal amount of wiring as possible. Too much wiring and too many new circuits to change over for 99+ wiring. More than likely will end up making some PCBs with a relay for this to operate in a stock pre 99.

I have the schematics that show all the connector wires going to a undetailed block. I want to know where the relay pins for the passenger side switch and circuit board go to. Does this schematic exist? I have this much figured out. Those traces look like I will fry them the instant I put all...

Wow thanks! I might have to make a control board for this once I poke around inside the pass. side master switch I will know more.

Bump

Bump

What did you do about the passenger side window and door lock switches? I can’t find schematics for specifically a 98 and 2002. All the FSM downloads are a general 4runner FSM.

Wow, didnt realize that was a change. What about the door lock? What have other done when doing this swap?