Recent content by Danger Mouse

thanks so much, that is what i was missing.

ok, the lock mechanisms in the wiring diagram are strange to me. there are 2 wires that go to the motor in the mechanism and 2 more that go to a switch in the mechanism. the motor side go to the ecm for the body control computer if i followed them right (they were about 6 pages apart so i...

thanks, hopefully that will get me where im going. ill check out the diagrams and see what i can figure out.

wow spaced on that didn't i 2002 limited

does anyone know which wires in the rear hatch come from the driver door switch to lock and unlock the gate (all locks). all of the wiring diagrams I can find show the front and back doors but none mention the hatch, liftgate whatever you want to call it. thanks

when I got my 2000 the fuel gauge didn't work. found a reset procedure on here somewhere, maybe it was a different 4runner site, not sure. after the reset mine has worked without issue for the past year.

glad you found the problem. for anyone else chasing a misfire I found mine to be a coil pack was going bad and replacing it fixed mine.

I swapped the hatch on mine when I bought it a year ago since it was pretty mashed. pulled all the wiring and fed it into the new one since it used a different control computer. I remember the screw holes were broken and I replaced/repaired them with epoxy putty. if I remember right the...

like many others have experienced I had issues with my rear hatch not unlocking with the key sometimes. after making and installing an interior hatch release it also didnt want to unlock with the power unlock most of the time. after quita a bit of fiddling around I found the metal and plastic...

fusable link?

did you do a compression test on the cylinder or just the injector? bad valve might leak enough fuel /air mix to stop it from firing correctly. the original poster's sounds like an injector, and the one I had turned out to be the coil pack, but if you've already done those, and wires and...

does anyone know if the spark plug tubes can be removed without damaging them and what is used to reset them once removed. I was replacing spark plugs on my project and 5 came out normally. the last one looks like someone took an impact wrench to it and ground it round so sockets can't get a...

I had to do my rear doors since the previous owner chopped the wiring harness to both if them :wow: had to trim and solder each pair of wire ends and wrap with electrical tape. you should be able to part the wires slightly and slip some electrical tape through and isolate the wires so whichever...

weren't driving out to colorado were you :police:

mine ran out of gas driving home when I bought it showing 3/4 full called the school I got it from to see if they knew why it suddenly wouldnt start or run when it had been fine when I test drove and picked it up. OH gas gague doesnt work forgot about that :mmph: tank was crushed up about 3-4...