Recent content by Dr Gonzo

The piece that I am looking for is not in that picture, but the push rod that is in that pic is what is connected to the bracket. I believe that it is in the same spot where the spring goes under the pedal.

A picture would make this so much simpler. I went home to get on, and realized that my buddy that took the clutch pedal also took the bracket. FML.

I can't see this on my work PC. I will have to check it out when I get home.

I appreciate your help, but that is not quite what I am looking for.

So, I got my new clutch installed but still couldn't get it to work. I replaced the slave and it was moving the fork about a half an inch. Since it was able to push on it, just not with enough movement, I replaced the master as well. Here is the problem. While digging around under the...

1. I believe so. I will get the part numbers when I go home for lunch. 2. I believe so. I hope so.

I did NOT use a torque wrench. If the bolts are not tightened to the exact right amount, would that be the issue?

I did tried that already. Made the pedal feel like it should, but still didn't find any of the gears.

Hey guys, I need some help. Last weekend I installed a new clutch in my '87. Not a whole lot of issues while disassembling and putting everything back went pretty easy as well. Until i tried to see if it worked. When I start it up while it is in gear, as soon as i make the smallest move on...

I did just that. Checked the backs as well. Calipers were a breeze. Until I started to try and bleed them and wasn't getting any fluid to the brake. I couldn't figure it out. Until my friend was looking at the MC while I was pumping the brakes and he noticed that the gasket for the...

I'm not sure both are bad. One is seized up so i just figured if I was going to do one, might as well do both. They both look to be in pretty bad shape.

So after changing my front brake pads I found out that I need to change the calipers as well. I have never done the calipers before. Is there anything special that needs to be taken into account? Or is it pretty cut and dry? Thank you

Still got the safari bar?

Perfect. Thanks for the suggestions.

I have an 87 that I bought a little while ago. The seats in there suck and make it very uncomfortable when I go off road. What seats would be the best to replace the originals? Thanks