Recent content by eric_rosenwald

So my Manfrotto video tripod got blasted with spray paint during a video shoot. Do you guys have any recommendations on removing it? Without damaging the plastic, and what appears to be powder-coated paint-covered metal parts, and a rubber grip. That may be tough, and I know I won't be able...

This one is simple: How do I get access to the bolt(s) that I need to tighten? I took off the panel/trim/whatever, but it wasn't at all obvious how to reach the bolt that was apparently loose. Thankfully, it doesn't interfere with shifting gears. However, it's really annoying when I'm...

Here's their second response, when I asked what type of primer I should use: "Hi Eric, HERE is a really good primer.Automotive grade. It's not cheap, but its' a good one. Before primer, I'd steel wool it real well to remove all dirt. It then scores the surface for the primer to adhere...

YAKIMA'S Response YAKIMA'S RESPONSE: Hi Eric, "Thank you for contacting Yakima support. It's powder coated. I'd use a wire brush and remove as much as possible. Then primer and then paint. I'd use a good quality out door element type paint. At the least a Rust O leum type product. Let...

I have a Yakima LoadWarrior. I take good care of it, but there's been enough wear in some parts that the paint was worn down, and it eventually went to the bare metal. There is light rusting, but nothing that keeps it from being unusable. I did my best to clean it off, but there's still some...

I should be more specific: I would be taking it in the battery box (thanks for the recommendation) a maximum of 5 days per month. Otherwise, I can leave it connected to the charger / maintainer in my house. Given that, what kind of charging schedule/method would you recommend?

So it's essentially like a normal car battery, but just using a spill-proof technology? If so, are AGM batteries hard to find for a 200k T4R?

Also: I assume that after I buy the battery, I should have it plugged in with a trickle charger all the time. Or is it better to do something else? since it's new?

The battery would solely be be intended to install as a new battery. I have a GoalZero solar setup and I love it! What's an AGM battery? Thanks

I want to start bringing an extra battery with me on my 4WD trips to isolated places. What's the best way for me to secure the battery? Is there an enclosure that would work well? I'd like to be able to pack it in with plenty of other gear. If it were in a sturdy box or something, I imagine it...

I got a safety flag for my 4Runner. I use a Yakima MegaWarrior roof rack (with extension). The flag hardware has a fork in it that is usually attached to an axle. I want to know how to attach it to a roof rack bar. It looks like a simple case of using the right hardware, but I don't know the...

A classic solution! I think I'll go this route first... I don't necessarily need my gear hermetically sealed (husky cargo equipment) right now. Plus the canvas option is cheap! and time-tested Thanks!

Thanks for the info! This is a great suggestion. I'll go this route when I need maximum protection! I'm in the desert so I don't necessarily need it all the time. But I also go on long trips into wet areas and this will seal up everything perfectly when I need total dryness (electronic equipment...

I use a Yakima MegaWarrior with a "StretchNet" -- an elastic net that attaches to the roof rack, over your gear. To weatherproof my roof stuff, I usually put the gear up, cover it with a tarp, then put the net on. Tarps suck! The square spaces move, and it tends to gradually put holes in the...

I know what you mean. I faced the same issue when I removed them. But some good polish/paint treatment helps, even if it won't completely remove the effect on the paint.