Recent content by FamousAv8er

This is a powered sub so not a standard setup (Kicker HS8) but thank you for the response.

Im referring to the voltage (possibly range) I should be seeing if I test the speakers incoming wire. for more information Im troubleshooting a powered sub that taps into the rear door speaker wires.

Im to troubleshoot my system. Could anyone please tell me the output voltage I should be seeing for my left and right rear door speakers (+ & -)? I have a non JBL with Nav.

The bolt is M10 x 1.25 x 30mm

I was planning to use a drivers seat bolt as a ground but the bolt is painted. I need one of two things. I either need locations where I could possibly ground my amp. This would need to be near the drivers seat. OR I need to know the specs of the drivers seat bolts so that I may buy an...

It looks like another option would be to use DC Offset Turn-On but I will need to look into how this works.

It looks like another option would be to se DC Offset Turn-On but I will need to look at how to do this.

I would want to verify that that is 12V and I would want to assure that that would cause no issues with my satellite radio because I use that often.

I purchased a Kicker HS8 Powered Sub. I am ready to run the wiring but I am not sure where I should tap into for the remote power/turn-on. I have a 5th Gen non JBL w/nav. Below is a wiring sheet I found online which seems to be fairly accurate. There is no Factory Amp or Power Antenna values...

It looks like the Factory Amp Turn-On has the value "N/A" which leads me to believe there is no wire for this available.

Looking for any location that I could use for this wire without harming anything. Would be open to using any CD player wires if that is possible as it has never/ will never be used (by me).

Been referring to ANTMAN's thread but no information about remote power wire. ANTMAN'S Thread

I found this wiring sheet for a 5th gen. Mine is non JBL w/ nav. Still not sure which to tap in to.

Ive decided to install a Kicker HS8 powered sub in my `17 T4R. I plan to use the remote power wire so that the sub powers on when the vehicle is powered on. Which wire on the head unit would I need to tap into to accomplish this?

SOLVED So I took it to the dealership early this morning. I just received a call from my tech. Apparently (according to the master tech), my LCA was loose. They torqued to spec and noise is apparently gone.A tad annoyed my request to check torque was ignored but at lease I dont have an expensive...