Recent content by fastboarder

I am replying to an older post but was was curious if any of our experts knew if the yellow was the driver side turn signal (left) and if one of the light blue wires was the passenger (right) blinker? Would match the engine compartment coloring. If anyone has pin assignments that would be really...

Know this is an old thread. Question though, I have torn apart the truck once again (prior 2016) and since I have it opened up thought I would do this mod. Took a look at the connector and at least to my eyes, I do not see any wire in the pin 5 position. Does this carry over to the 16's or is...

Thanks for the tips! I never thought to use a needle on those small gauge wires. Brilliant. Probably going to cheat and bring the previously wired switches, tie into those, run the wires up, and use those wires for my illumination as I know they are accessible and work. Those overhead consoles...

I guess I should add, I have installed these switches on the left side of the steering problem. In the overhead console, there are a couple of green shades and I believe two "grayish" wires in the wires feeding the switches. Afraid to take a multimeter to these and poking as these wires are so...

Know this is old but wanted to see if anyone could answer where you pulled the illumination from in this console? Have pretty much the same setup, just curious where to pull the interior lighting from?

Know this is an older post but it was helpful for me. For those of us that do not have or have access to a 3D printer this might help. I tried to figure out what I could use as a mount like the gents who created the plastic piece in the clean installs above. Somehow a moment of genius was...

Thanks! I found a how to on eTrailer. Basically one you have to pry up and the other is a tab. I have done a ton of mods over the years but disconnecting these two had me cursing.

Amazon is running a special... Sorry, had to...:rofl:

Need a bit of help. I've exhausted the search function which comes up with plenty of how to's in extending the factory harness. My question is how to detach or unclip the 2 OEM connectors which go to the OEM 7 pin connector? Before I get mad and get start yanking I am going to take a break and...

Thanks matoolie! For the second time in its life, my Runner is stripped down completely inside. Fingers crossed I don't burn it down to the frame, install happening this weekend!

matoolie Appreciate your help and even more so your patience lol. For pin 1 is that going to a 12V fused line? Just realized no power comes across the optocoupler and didn't realize your intent where the switch is, 12V is on the pin 1 wire. Is this correct? Thanks again!

matoolie Well, here is my best guess at what the circuit looks like based on your input. Can you advise if you think this will fly; better yet not make my rig look like Cheech and Chong with clouds of smoke? For the life of me, not sure why the images aren't showing up here...here is a link to...

matoolie Let's see if this will let me post some pics. I took your circuit layout and used my Paint skills to modify it to represent what I was talking about above. Basically since the cap on the SSR is keeping the voltage constant, the output trigger and subsequent triggers will not have the...