Recent content by heron163

That is what I thought re. the longer axle length... thank you for confirming it. Does this look like an extreme angle? <blockquote class="imgur-embed-pub" lang="en" data-id="a/PLcVYg6"><a href="//imgur.com/PLcVYg6"></a></blockquote><script async src="//s.imgur.com/min/embed.js"...

Trying to find out if this will help reduce the angle I currently have. 60K miles on my 2016 runner and outer boots failed and joints making a lot of noise and vibration. Truck is lifted about three inches over stock. Looking at the extended offerings from CJV as an option but I would like to...

no plans for the SR8 17" for the 4Runner?:confused:

I am thinking of going with these. from what I can tell, the offset (4.75") should be comparable to the stock wheels. thoughts?

I had the tire shop do mine... it is a two step process. 1. initialize or wake up sensors 2. key to vehicle

thanks - I am definitely doing this with EPDM rapper sheeting from Grainger.

I need to make a set - where did you get the extra push pins? thanks

can you briefly describe what you did? did you move the liner or what? thank you

Toyo AT's

Added Fox Factory 2.5 remote reservoirs w/ lift. Right now, I would say it needs some + camber. Some rubbing when backing up. I have not moved fender liners/splash guards yet. The tires are 285/70-17 on Konig counter steers. Once I get some time on it, will probably make some adjustments. Rudy...

what exactly did you do to modify the drivers side mounting bracket? It looks like you cut of the part that would be below the reservoir (the part of the bracket that would be horizontal when installed). Is this correct? thanks

you said earlier in this thread that you did... or is it Chas whipping these up in his spare time...:pound:

I thought you made these "in house"?

dont worry about some thread showing - as long as it is secure and at the right orientation to add grease when you need to, everything is good

most zerks are not torqued to extreme values (they can break pretty easily if over tightened which has led to my experience in extracting broken ones:madgrin:) and a broken one is pretty easy to remove with an extractor tool. In a worst case, once it cas been removed, run a tap through to clean...