Recent content by huntsonora

unreal work

Looking to take my rails off and install a factory roof rack. I have the silicone but don’t know which loctite to use. Loctite on the bottom and silicone at the top correct?

Thanks guys. This is a difficult decision but after spending the weekend going through the 4Runner and power washing the undercarriage, giving it a thorough cleaning and waxing I’m thinking I’m going to keep it and pass on the Tacoma. I’m dialed in with suspension, tire size, preventative...

My 4Runner Tacoma thinking about buying

My fault! It’s an 06 Tacoma with new 285/75/17 bfg’s, rough country 3” Coil overs, bed rug, leer topper. 2 owner, both middle aged and not wheeled hard

I have a 97 4Runner SR5 with leather seats, sunroof, 5 speed and a from the factory elocker. It has 200,000 miles on it and I may sell it. I know the 4Runners with the 5 speed and elocker are rare but don’t know if it adds that much more value. I have new LBJ’s and an ARB suspension on it both...

Get it working?

Does anybody know if the Rotella T6 is still ok to run in gas engines? It doesn’t have the SN rating anymore Thanks!

Thanks! I about choked when he told me the prices. I took a picture of the invoice before I left The price I stated was with tax but it’s still a ripoff

Drove to Ehrlich Toyota here in Greeley CO and they wanted $27 for the pcv valve, $11 for the grommet and $24 for the replacement vacuum line. Is this normal? I was surprised it was that high. Headed to NAPA now....

Thank you for this tip! Went to ace, picked out 4 rubber washers and 5 minutes later there were no more rattles

I’m running Rotella T6 5w30 multi car in my 97 and it’s running like a top and I’m sure keeping everything cleaned up nicely Ran it in my 06 Tundra with the 2UZ-FE engine and it was awfully quiet

I’m just here to see the difference once you pull the valve covers

No sir, it’s a 5w30 and it’s available through Oreillys or NAPA. It was a unicorn for a while https://www.napaonline.com/en/p/SHR550046251