Recent content by innocent bystander

Oh.... Non-KDSS. Just an SR5

I am sure you are right, but I am having a hard time finding any.

Looking to put greasable sway bar bushings on the front to frame of my 5th generation. I can't seem to find the size anywhere though. I measured it as 30mm, is that correct? Thanks

Taking the sway bar off can be a pain if not on a lift, but pretty straight forward. Worth the time to take it off and see if it goes away.

One last update to this... noticed under certain conditions that I still had a slight clunk. Got frustrated and took the following actions: Took off the skid plate - NO DIFFERENCE Took off sway bar completely - CLUNK GONE With the end links being replaced, had to be the bushings. I went on...

Thought I would update anyone interested. I replaced the sway bar end links and everything is back to normal. Upon taking them off though, I noticed ZERO play in them. The ball joints were quite loose, but I could yank them around and feel any play. The feel and sound are just incredibly...

That is my understanding as well, which is one reason I tend to have that further down the list of my potential solutions. Can anyone confirm that the 4th Gen and 5th Gen sway bar end links are the same?

Thanks for the quick reply. When you reference the UCAs, are you referring to replacing the entire arm, or just the bushings?

Lots of threads, I know, also a lot to dig through though. Information overload, so I am going to start a fresh thread if that is ok. 2010 SR5 with 87k miles. Getting a bit of a clunk when going over uneven bumps at slower speeds. Can't so much FEEL it yet, but it is very audible...

I thought about removing it, but I am mainly riding on the road. Are you using your mainly for off-road?

I am experiencing a slight clunk in my front end when going over some low speed bumps. I went over the skid plate and it is on properly and tight. Next common cause seems to be sway bar bushings. Is there a kit somewhere that includes ALL of the bushings (mount and end links)? 5th generation...

I thank you and apologize at the same time. I did search the forum, but actually did not come across that thread. Very helpful.

Hey guys, I am looking at a couple of good sized popup campers, a Coleman Utah and a Coleman Bayside Elite. Both have spec'd weights of about 2600 lbs, and add some gear on top of that, I am guessing a gross weight of about 3500 pounds. For reference, they both have a 12 foot box. I have a...

Anyone else have this? It got to the point where the rear center armrest/cup holder had about 1/2 of back and forth play. It was clacking and rattling over every bump, in either the up or down position. So I dug into it today. On the passenger side, with the armrest in the down position...

2010 T4R SR5. Slid out of the driveway in an ice storm into the neighbors fence. Small crack in front bumper skin. Black in color. Anyone upgrading the front bumper and would like to sell their OEM bumper cover give me a shout.