Recent content by jacksparrow

Hate to sell my 2017 TRD PRO but started school again and need $$$ to pay for tuition. Year: 2017 Trim: TRD PRO Color: Cement Miles: 7007 Upgrades/Mods/Accessories: Xpel paint protection film for complete front end (bumper, hood, fenders, door handle area, part of roof). Front windows tinted to...

Glad to know that cement pro’s are holding their value. I started school this past week and will most probably put mine up for sale in a month or two. I have the same sliders as you have...very well built.

I installed mine 6 months ago and took about the same time....~2.5 hrs for the passenger side and ~45 mins for the driver side. Hope OP gets some help instead of selling them.

They are bolt on but the use of stick nuts complicates the process. I wish Shockworks updated their design to match existing bolt hole locations on the frame....

That is just way too bold. Rethink your decision.

Turn the Temperature knob slightly clockwise and then push A/C button. A/C is always ON if the temp knob is the set to the coldest temp.

It locks in place and has 2 locking positions when you pull the tray out. I would highly recommend it for dogs and it also protects the rear bumper from scratches when they jump in/out.

Looks sharp with the tint but is that legal in your state? Also, how is the visibility at night?

Thanks for your reply.

Did you have to cut the carpet on the inside to feed the wires thru? Can you please take a picture of the inside of the cabin where the wire enters the cabin?

How did you guys feed the wires thru the firewall? I took the rubber grommet off but don't see an opening into the cabin. Do I have to cut the carpet to feed the wires thru? Everything is wired up except for this part. A picture of the inside of the cabin where where the wire(s) is fed thru...

Keep us updated on how they perform off-road.

Try to get it down to $36,500 no accessories but with moonroof. That would be a great price.

The picture I posted in this thread is from my trip to Whitaker Point trail in Arkansas. Last 5 miles or so is dirt road. Trail was very scenic.

I bought these after reading your review but they don't seem to fit right. The cord that exits the LED housing is interfering with the headlight housing and therefore can't lock it in place. Am I not doing it right? Is there a trick to installing these?