Recent content by jcramsey

Have a Tom Woods double cardan driveshaft for a lifted 3rd gen that's in great shape. Have the yoke as well, its just not pictured. Can get the measurements if you need them. Located in Marion, NC $450

Powerstop KCOE2324 rotor/caliper/pads kit for a 2000-2005. I had it installed for a couple hundred miles but could never get it dialed in, so I switched back to stock brakes. Sold the 4Runner so these are just sitting around. Located in Marion, NC $295

sold

3rd gen OME 891x rear springs with bump stops. In great shape $200 obo Located in Marion, NC

3rd gen e-locker rear axle in good shape. Solenoid wiring is intact.Missing one drum and has one bad wheel stud. I think it’s 4.30 gear ratio. Will try to confirm that. Located in Marion,NC $1000 obo

Jeez...apparently I posted a question and never checked this thread again. What a jerk! I appreciate the replies. 4Runner is in my driveway and still going strong!

Thanks!

One more bump to see if anybody can confirm that these are the same across the board before I go ahead and buy some. Thanks!

Thanks. Yea the price seems a little too good to be true considering the 8mm cone washers from Toyota are like $5 apiece.

I've got a 2000 4Runner with a manual hub conversion using parts from a 1st gen Tacoma. Previous owner had no cone washers or nuts holding the hubs on. I see plenty of companies that carry the studs and hardware for the Aisin hubs, but they all say they're for 86-95 Toyota trucks or...

The 4runner I just bought has the SS 1.2 kit on it. My previous 2wd I pieced together basically the same the lift with Bilstein 5100's/Eibach 3" springs, Landcruiser 7.5 wraps and Tokico Landcruiser shocks. Both setups work great for me as a DD, and I imagine will serve me well if I...

Just bought this a month or so ago and it came from the Phoenix area I believe. I know a few of the mods done to it, but looking to see if I can find the PO prior to the guy I bought it from to see if I can get more details/hisotry on it. I believe his name was Brian Koch. 2000 sport, with...

Two weeks ago...replaced both front wheel bearings and a new hub on passenger side. This past weekend, installed SPC upper control arms so I could get the camber back within spec. Hopefully done spending money on this thing for a while!

PM’ed you.

I jusr picked up a 2000 with the Sonoran 1.2 kit a 2” body lift (not usually a fan of that) and 285/70/17. Only driven it once since I got it because it needed both wheel bearings replaced but even then the ride quality was really nice.