Recent content by JRapid

I said the same thing, needs an engine cover bad. Wiring is a mess

I think the biggest takeaway is the much needed power upgrade. 465 torque is solid. The looks will grow on people like they do with every other car. Look at how people hated the new M4's at first.

I'm having the same issue with my passenger side low-beam. After I turn off the truck it goes out till I wiggle it again. I've been wanting to upgrade to HID's so this might be the perfect time :D

I did mine a few days ago because I was having some pretty bad clucking. So far so good. I used green grease like someone else mentioned. Here's a short clip pumping out the old stuff. _L_uZRWQTBg

Don't think I ever sent you a pic of mine mounted, so here yah go! Style A 8" in silver

bump

SOLD

Such a relief isn't it, finally replaced mine a few weeks ago. I had some bad seizing going on...

Yep sparky nailed it. I got 4 cans, did 4 coats of black each, and did 3 coats of matte clear on top. You could probably get away with using 3 cans because I have plenty left over. I really do suggest clear coating though. It feels much more durable than just the plasti dip alone.

Plasti dipped the wheels today

I've noticed that too, and that's why I'm considering putting the 2.5's up front and leaving the rears alone.

229k on my 06 v8 4x4

Lamin-x fog light covers $20 Headlight, Tail Light, Fog Light Film Covers & Paint Protection Products from Lamin-x

Finally did the headlight mod http://www.toyota-4runner.org/2622280-post163.html

I did this mod today and wanted to share my results. Overall it was pretty straight forward following the OP instructions. As stated that 4th screw to remove the housing is a b**** but take your time with this, if you rush you won't get the best results. I made sure I took plenty of pictures...