Recent content by JUICE222

I'm down to go if it's cool. Sounds like fun.

What’s up wrpsuite, I just put the same dent on mine last week on on an off road trip. I was planning on starting tomorrow on an attempt to fix it. I was under the impression that it would be accessible by removing the interior panel in the rear section. The rear limited flare on mine is...

I had a leak that look similar to that on my 4runner. I found the leak was coming from the rubber piece area with yellow paint mark below the flange. Its part of the rack and pinion. I was not able to find any repair kits for it at the time. I ended up replacing the rack and pinion. I never...

Completed 13WL tundra brake upgrade and SS brake lines.

I’m in the process of installing an X2O 10k winch on my AOR tube bumper. It appears I will be doing some minor trimming on the grill.

Removed and replaced lower control arm bushings. Attempted driveway alignment.

Finished replacing timing belt and associated parts included with kit. Installed new radiator and a transmission external cooler.

Me too! Only in this site.

I don’t know how to upload pictures yet. With 4runner specific 5100 on lowest perch, OME 880/906 setup I have 1/2” rake. Center of wheel to fender front 21.5” rear 22” with trim packer installed. Hope this answers your question.

Installed differential drop kit. Disappointed on the outcome. Cannot tell a difference on the CV angles. Looks pretty much exactly the same. Going to review it tomorrow. Maybe remove it. That sucks.

Sorry to hear about your situation. Sounds like it could have been worse. Im sure you’ll find a good shop. Today installed SPC upper control arms and brake fluid flush.

I went with energy suspension polyurethane bushings on my steering rack. Solved my problem of excessive play.

Just want to say thank you for the videos Tim and Sean. Just replaced steering rack and tie rods on my 4Runner today. Keep up the good work!

Today I replaced the steering rack & tie rods on my 4Runner.

My 4runner has an annoying rattle only when pressing on the accelerator. It seems to be coming from underneath the truck. Going to check some of the things you guys suggested. Thanks for all the tips.