Recent content by Kevin Deshler

Hey everyone Im stumped. 99 4runner limited 4x4. With ABS. After driving for 5 to 10 minutes my front brakes lock up. Heres what has already been done. 1. New Calipers 2. New Soft brake hoses front and rear 3. New brake rear pistons 4. New Mater Cylinder 5. New Fluid Dot 3 6. New abs module...

No how do I check it? Sent from my iPhone using Tapatalk

Help please

I actually did that twice because I thought the first one was defective.

They will spin if I release pressure on the bleeder. And it doesnt start as a full lock up it works up to that after dragging for a minute or two. Could cheap brake fluid cause this Im using wearever brake fluid that I got from Advanced auto parts.

Hey everyone Im stumped. 99 4runner limited 4x4. With ABS. After driving for 5 to 10 minutes my front brakes lock up. Heres what has already been done. 1. New Calipers 2. New Soft brake hoses front and rear 3. New brake rear pistons 4. New Mater Cylinder 5. New Fluid Dot 3 6. New abs...

Looking for this part number for neutral position switch. Says 84222D but nothing comes up.

Is their a write up on how it goes back in correctly. I've looked everywhere. I'm not sure if it's working because my 4wd didn't work in the first place.

99 4wd. Light just flashes for 4wd constantly. Checked 3 sensors all ok. Check actuator front and rear check ok. Checked vac lines in front check ok. Is their a vac line on rear actuator or is that a breatger?

99 limited tape / cd 35 shipped

Ok I'm trying to find the 4 sensors that would possibly make my 4wd not work. I know there is one in the front differential, two right above the transfer case actuator and where is the 4th? I've checked the other three and they all check ok. I just need to check that 4th one.

Ok I took the top plate off which I was worried might mess something up. I was able to hold the gear in place and get it to spline on. Did bit fix my 4wd problem however

The gear inside the housing is like moving around how do I line it up?

99 4runner 3.4 rear actuator on transfer case. How do I get it back in?