Recent content by KwonRunner

https://imgur.com/a/pWrUKgw FS: 4th Gen 2008 Toyota 4Runner V6 4WD – 194K – Modified – $25,900 OBO – NorCal, CA Finally time to let my 4th gen go. It's a 2008 Toyota 4Runner V6 4WD with ~194k miles. It's been a California vehicle its entire life, garage kept, and is virtually rust-free. Clean...

Sorry about that. Just PM'd you.

FS 2 pairs of spidertrax spacers New and unused for $200 Decided not to install, picked up this past November, PM me https://i.imgur.com/OOKjuqx.jpg https://i.imgur.com/leF7nEc.jpg https://i.imgur.com/VysKJ6A.jpg

FS New 1.25" spidertrax spacers x4, for $200 FS 2 pairs of spidertrax spacers New and unused for $200 Decided not to install, picked up this past November https://i.imgur.com/OOKjuqx.jpg https://i.imgur.com/leF7nEc.jpg https://i.imgur.com/VysKJ6A.jpg

Thanks! Messed with the harness a bit and she's back to normal! :whoo:

Thanks again for organizing the meet. Nice meeting ya'll and fun trail. Just FYI, with the crappy knock sensor code, the truck went into limp mode so I just used AAA :thumb3:

Waddup gang. I'm up for signal peak if you got room for 1 more.

I'd say it's not a bad thing to get, even with a mild lift. I have at least 2" in the back, ~3" in the front. I've broken a rear link mount before and want to prevent that. I've also heard of the front links potentially breaking and messing up your CVs. If you're doing mild wheeling, you should...

Thanks for that recommendation. Found some more info on t4r and am leaning towards either 1) the Proforged 113-10144 Link + energy suspension grommets for the rear and take off the front sway bar or 2) just get the front and rear OCD links

Dobinsons vs OCD? Just Rear vs Front and Rear? Pros vs. Cons?

Shock guards Using these myself BPF 4runner 04-21 /FJ 07-14 Shock Guards I don't think rago makes them for 4th gens

Just wanted to update the community. Good news. That terrible noise was not coming from the front nor the cv axles, but the rear of the vehicle. Turns out a carriage bolt on my fuel skid was backwards and making contact with the drive shaft when flexed. PSA for those with RCI fuel skids...

Love this forum. Good guess, but I don't think so. I've had my setup for a while and have been using it on and offroad with nothing like this happening. I remember the sound of tires rubbing my body mount back before I got it chopped and it's nothing like this clacking. I have ~3" in the front...

Video of the noise 4runner on Vimeo

Thanks for all the feedback! :usa2: I'll try to see if it's the bearings by jacking her up and turning the wheel. To clarify more, this happens mostly when I turn right onto a slight incline, like a driveway or into a parkinglot. I usually don't get it when I make a normal right. The slower I...