Recent content by kzink

i need to buy a dashopt assembly for my 94 3vze no one sells one but the dealership and they want an arm and a leg let me know if anyone has one they would like to sell

my question now is with it throwing code 25, a lean code, will the hc go up when i fix the problem? i already have high hc or could it be a bad o2 saying its running lean so my ecu is adding more fuel(higher hc) and my o2 is still reporting a lean code because its just stuck sending a lean...

Just checked the codes and it's throwing code 25

I have not checked for codes yet I will tomorrow and go from there

i went to get my 94 4runner 3.0 5speed smogged a few days ago and failed with a few issues one was tape on the intake boot, (it has a small cut) a line unplugged, and high hc. at 15mph it was like 4 times the allowed amount and then at 25mph it was at the limit mark. i looked to see what line...

yea easy to replace pull off the rear drum hammer out the broken stud and get 2 new ones as well as one extra lug nut. put about 10 washers on the new stud and tighten one of the old lug nuts on till it gets pulled through. use the same lug nut to pull both through and then toss that one.

im not looking for performance gains im looking to pass smog, and i have an extra 2.5 in/out turbo muffler at the house so i was going to use that. i just wanted to make sure it wouldnt be to big or what not, stock is what 2.125 or 2.25? so i was going going to run stock to the flange after the...

well i am in need of a new catalytic converter for my smog check coming up here in a few months and if you live in ca you know how much of a pia it can be. well i need a cat and while im down there im going to build a custom cat back exhaust using 2.5 in piping would this cat flow sufficient...

went out to the lake heading back to my favorite spot and you have to cross a little bit of the lake to get there and i have never seen it more then a foot deep so i walk out a few feet to make sure it didnt drop off....guess i didnt walk out far enough. motor shut off cab filled with water horn...

check rock auto real reasonable priced for parts. wouldnt hurt to rent a coolant system pressure tester from autozone and see where all your leaks are coming from, most coming from the rad can be fixed at a good rad shop.

on the cheap start with bj spacers and add a leafs then a 1in bl and some 33s, get yourself a good tow strap, doesn't matter how far you can make it in if you get stuck and cant make it out. investing in some hubs would not be a bad idea unless your plan on going sfa real soon. an external cage...

any plans for those steel wheels now?

going to order a bl and just wondering if getting the upgraded kit with the bigger blocks is worth the money

how much for rear driveline

yea im looking for an inch or inch and a half tops nothing to big