Recent content by millerjw

No lines were relocated and yes the washer reservoir is still there. They installed a plate in front of it. I plan on relocating the reservoir later and removing the plate.

So far I'm very satisfied. Still need to get off the road and try out the new approach angle.

Here is CBI's video on their facebook site. https://www.facebook.com/pages/CBI-Offroad-Fab/192981647417723?fref=ts

So talking with Nathan they do intend to make it available on their website. They just needed to finish up their jig so they can make more that will fit the 5th gens. I didn't ask about what they intend to list it for or the weight of it. They did give me a few options on the design. Obviously...

Here is the finished product.

I believe that is the plan. I think they wanted to get a couple in to iron out the kinks. I will ask Nathan at CBI when I pick up my truck tomorrow.

That the sensor is installed and they make no guarantees beyond that. As to if it deploys more often or less is for a smarter man then I to figure out. It would be the same risk with any aftermarket bumper with the exception of ARB I suppose.

Thanks, they are very easy to work with.

I stand corrected. So I don't know how they will react. The sensors are still installed according to CBI.

The air bag sensors are still there. Problem is the bumper is much more rigid then the plastic one. So it will take a larger impact to get them to deploy.

Here is my attempt at a better picture

Dropped my truck off at CBI on monday for a new bumper. Here is the progress so far.

Active Navy 19 Years O-3E Submarine Limited Duty Officer USS Nebraska (SSBN 739)

As someone who has been in the service for 19 years it still makes me proud that we have people like you who pay attention to those who serve. Thank you sir!!

I installed these as well. If you don't want to trim the plastic use a heat gun and get it soft. Then shut your hood. The trim will smooth down to allow the clearance needed.