Recent content by Notch46

PM sent on SS3

Post from back in 2017 when I made my own. I actually sell the template if people don't want to take the time to make there own. Made a lot for the 2nd Gen tacoma guys. https://www.toyota-4runner.org/5th-gen-t4rs/231263-upgraded-my-inner-fender-splash-shields.html#post2576312

Sorry guys I have not been able to get on here in a while. Yes I'm still looking for a set of black end caps. Don't need the whole rail set up just the caps. Shoot me a PM. Thanks

Looking for some "Black" TRD pro roof rack end caps for my 2016 SR5. I have the OEM silver ones to trade if needed. Let me know what you got. Thanks

The clips are not your normal xmas tree clip. Toyota uses some weird step style clip. I just used a long nose pliers and pulled them out. A trim removal tool would work as well. The rubber gets warm but not hot. I've had no issues on both my Runner and Tacoma.

Yeah the factory push pins are a joke. LoL.

You could but there would be seams for the water to get in. Also the factory ones are not the greatest. LoL.

My local Napa auto parts has the push pins. The bigger push pin works great for the factory holes. For the smaller pins I just drilled new smaller holes.

Not at the moment. It needs some time to break in. Its quiet at idle, part throttle, but give it some gas and it sounds nice. I feel the 4 Runner is more air tight then my Tacoma so maybe that's why it seems quiet. But Im glade I went with the 18" case over the 22" case. After break in Im sure...

I was finally able to get my magnaflow muffler installed yesterday. I ended up going with the #12256 SI/SO offset 18" case length. I run this same muffler on my 2015 Tacoma I love it. While I was there I decided to have them make the tail pipe come out the side. Just had them bend up a 90 degree...

The template I made is 14" x 37.5" I think you could trim it down to 36" and still be able to use the outer most factory mounting holes.

My local Ace only sells it by the foot. The roll is 12" wide and I bought 7'. Think I spent $38 so $5.49 a foot. Because it's only 12" wide I had to cut the template in half in order to make it fit within the 12". So it ends up being two pieces that I joined together with a xmas tree push pin...

Made a thread on it.

The stock inner fender splash shields (or lack of) are not the greatest. So I decided to make some better splash shields. I made some for my 2015 Tacoma, and 2014 F150 and they work great. I used some 1/16" sheet rubber that I found at my local Ace hardware. I designed and made a template then...

They are made out of 1/16" rubber. I made templates then cut them out of rubber. I used some plastic xmas tree push pins to attach them. Been doing this on all my trucks for years. Yes they would. Pm me if you want to make a set.