Recent content by Nubie4Runner

  1. Nubie4Runner

    Replacing headlight switch

    My issue was a fuse box molex connector that had 3 bad/corroded wires. All is good after fixing, saved hundreds!! Since I have a spare switch I thought I'd share a way to test it and check for fault before replacing. Pictured is pin layout and expected continuity of a working combo switch.
  2. Nubie4Runner

    FS: Headlight Combination switch for 96-98 T4R

    50$ + you pay shipping from Toronto Canada Message me or email; [email protected]
  3. Nubie4Runner

    Replacing headlight switch

    Just an update that dealership found the fuse block (inside/drivers side) is badly corroded/mouldy on the back. Makes sense cause I can see the silicone job the previous owner did on the windshield. So looks like water was is getting in, though I've never seen any water whatsoever at the feet...
  4. Nubie4Runner

    Replacing headlight switch

    So the exact problem still exists after replacing the combo switch! Interestingly I had to drive like 5 hours to get a replacement for 50$ and when I got home what'd ya know everything works fine! After seeing everything was normal I didn't bother replacing the switch until today when I come...
  5. Nubie4Runner

    Replacing headlight switch

    I tried removing the column housing by removing the 2 screws that are behind the steering wheel (have to turn the wheel to expose them) and then removed the 1 screw on the lower housing and it didn't seem to want to come apart. I didn't use any force or pry at all as I expected it to separate...
  6. Nubie4Runner

    Replacing headlight switch

    So after experiencing problems with headlights coming on their own, dash lights that wont turn off and hi-beams that behaved strange I searched around here and found that problem is likely the headlight combo switch. I had the dealer do a diagnostic and they came to the same result. My question...
  7. Nubie4Runner

    inner tie rod, steering rack & bushings

    just to update thread, Had the alignment and new tires done and the improvement is enough for me to delay the bushing replacement. Prob will opt for a new steering rack down the road instead.
  8. Nubie4Runner

    Lights come on & constant cabin chime

    just sharing some findings that after applying,winding electric tape all around the negative conduit lower area and the connector to the block rail. Drove in some good rain and then parked to see if it would recurr. No more problems so far. Haven't had the headlights or cabin chime at all...
  9. Nubie4Runner

    Lights come on & constant cabin chime

    Head Lights come on & constant cabin chime Hoping to get some help for a weird problem - I gave up searching and decided to post so sorry I could'nt do a readers digest version! So today after a good overnight rain I found my headlights on when they were switched off. Trying to turn them...
  10. Nubie4Runner

    inner tie rod, steering rack & bushings

    Yes I saw that and when I checked my rack I could see I have the old steering rack guide. I have the old outer hex cap which means the old bearing type is in there. I will replace that with newer OEM upgrade and hope it solves the inner tie rod play. I don't really notice any clunking at all and...
  11. Nubie4Runner

    inner tie rod, steering rack & bushings

    Thx to such a great forum!! I'm a new 4runner owner - 96 SR5 237Km. I love this truck, interior wise everything works perfectly. Somthing I'm not used to with most domestics. Rear window, power antenna, etc. all is good. My problem; getting saftey inspection, Toyota dealership said inner tie...

Members online

Forum statistics

Threads
278,309
Messages
3,554,071
Members
248,016
Latest member
Advally Service
Back
Top