Recent content by nuron

What ever happened to the 90-degree o2 sensor spacers? Can't seem to find them on ebay or amazon anymore...

I would guess it's because the inside holes aren't chamfered, and instead are hard 90 degree angles, which means they might tear up soft shackles. I'm planning to chamfer the ones I have.

Great pictures! Thanks again. Sounds like an alternator. You can typically rebuild with just a brush kit but that's up to you. I replaced the alternator brush kit before it wears out | IH8MUD Forum

That is an aftermarket item. See where it traces to. Do you have a multimeter? Once an engine is running, voltage at the battery terminals should read ~14V to indicate a good alternator.

Hey man, thanks for all your help so far. I looked at the picture you posted in the Armor thread and it made me try installing the skid plate again. Judging by my view compared to yours, it seems like I have the right plate: I just called RCI today to get the spacers and they said it...

How much clearance did the spacers from RCI provide between the skid plate and the exhaust?

Got the crossbrace installed today--had to clearance and enlarge the bolt slot on the driver side (next to gas tank) to squeeze in the bolt. Running a bolt through that hole beforehand with some cutting fluid will definitely help with when you install with the crossbrace. I'm just going to send...

Oof, I think RCI may have sent me the correct crossbrace (bolt hole is offset) but the actual guard is incorrect. I did have to specify that mine is a V8 so not sure how much that makes a difference. It is 17.5", which, judging by your pics, that it's for a 5th gen. However, the tag for the...

While we're on the topic of transfer case skids, I just ordered one from RCI because of their 15% sale. Never liked how exposed the transfer case is in stock form--this will give me peace of mind knowing it's protected from the elements.

Interested to know your cost for this as well, thanks!

Does anyone have this tool that I can rent/buy? I can email you a prepaid shipping label. Not trying to pay the $40 that ECGS is asking on their website. Thanks in advance.

Same here. I've bled all four corners on my old brakes before and it was fine. Installed new components this time around and the brakes don't feel that good. I think I let the line disconnect for too long and air got deep into the system. Will be doing a longer flush multiple times around all...

I'm in the processing of rebuilding this OEM axle and saw a small amount of play in the Birfield joint: 20200405 185548 GIF | Gfycat Is this normal or should I just trash it?

Has anybody tried these assemblies: 2005-2015 Fit Toyota Tacoma 4X4 Front Wheel Hub &amp Koyo Bearing Assembly | eBay The ad says they're Koyo bearings but I don't see the stamping in the pictures. I messaged the seller so we'll see what they say. These ones for sure say Koyo, but more...

Can you share more details about your build? What projectors did you go with, and did you use the pre-made 4th gen projector brackets? Would love to see output shots as well! Planning to do a retrofit once Lightwerkz has a sale.