Recent content by nykhannan

Attached this to the back of the 3rd gen. XTR trailer I picked up for a mad deal out at blue water marine and cart in AL.

So I'm trying to run the compressor in the rear cargo area. This is the witing solution I have planned. Any input would be nice. ***NOTE*** I looked for write up's and diagrams but apparently the only rhing anyone cares about with an ARB compressor is where to mount it.

PAYED Sent from my SM-G960U using Tapatalk

I'm in for a dual. CKMTA12 Sent from my SM-G960U using Tapatalk

no guru As far as normal driving and what not, I no longer rub after my lift. Granted driving a 3rd gen and street driving gave me clearance for 33x12.5 tires. When I'm fully compressed obviously it rubs but not until then. A body lift would definitely help if you still rubbed during street...

99 Limited Looking for a Automatic Climate Control unit. Don't need the wiring just the deck itself.

Optronics Mini License Plate Light Part #: LP31CS Is what I used, then found where i wanted it tapped a hole in the bumper for the screws and put it in. Its super bright and use it to back up now. For wiring i ran it to my tail light wiring so it's only on when my lights are on. Super clean...

You should let me know what you come up with on your vibration. Replaced everything in front end so have come to the conclusion its Tran or Motor mounts or unbalanced tires.

ATF smells, not like fish or trash but weird chemical, rubber, plastic smell. My return lines had busted fortunately as I pulled into the garage but wouldn't do a thing accept rev. When those return lines break it could just be a hole smaller than a needle but spewing out a quart a minute when...

@mikesayboom and @nchacon1984 mikesayboom and nchacon1984 NEO3-GHP-- CLIMATE CONTROL AND INSTRUMENT PANEL NEO4-WHP-- CLIMATE CONTROL AND INSTRUMENT PANEL BA9S-RP5 -- MAP LIGHTS They work on contact so if they are dimming out means they are loose and not making full contact on the stupid...

I don't sorry. I'm real bad about stopping and taking photos I get in the groove. Essentially I cut everything out what makes it look weird on the 99 grill is the taper it has and the center support bulges out. I used a heat gun heating the plastic under the chrome so I could bend it to the...

A version of the satoshi mod definitely ventured on a limb and whoever said it doesn't look right with the limited 99 grille, here's proof it can be done. Also threw down on the hella fog lights.

Finally finished up building the tire gate

Threw in the sonoran steel 1.2 kit and CBI bumpers with a warn VR. Did the TB upgrade and fab'd mounting bars for the roof rack added some H3's to the rack and remounted the rest of my lights on the bumper. Currently in the process of making some ditch light mounts and waiting on some parts to...

Use MAP gas for 5 minutes, pb blaster, let it sit for 15 smack the face with a hammer. Repeat another time and it'll pop right off.