Recent content by pink_sleeve

What type of flare and fittings?

Does anyone know what size the rear main brake lines are? Assuming 3/16. Seems like any info on brake lines is next to impossible to find on these.

Shouldn’t the data ground register 12v? Mine registers like 1.

2001 SR5. I am getting a linking error at the OBD2 port. No blown fuses. Pin 16 has power. Pin 4 to 16 shows around 12 volts. Pin 5 to 16 shows less then 1 volt. And the other pins 15 and 7 I’m not sure how to check for continuity. I’m not even sure what pin 5 should read. I can’t seem to find a...

Neglected my driveshaft for to long so I don’t think it’s rebuildable at this point. Question is the 96-00 center rear driveshaft different then the 01-02 for the SR5 4wd. I can’t find any searching eBay that are used for 01-02. Just 00 and earlier or 03 and later. Though even those look the same?

The lines coming out of the brake booster going to the rear which one is the right rear and which is the left rear?

I do not hear a click from the back door like it is unlocking. Just see, hear the motor working. I've tried spraying in there with wd40 a couple times hoping it would start working.

I've tried even a pry bar. I don't think it's unlocking. I've tried sequencing the locks several times with no luck. I even unplugged it and tried unlocking with the key manually. Is there some way to get the mechanism out with the door still closed? I've been trying to get this stupid thing to...

I tried disconnecting the battery several times, and using the key. I don't think it is unlocking?

My rear lift gate will not open. You can hear the motor and watch the levers move with the cover off. I've also tried pulling up in both levers like I've saw in some videos. It still will not open. What gives?

Anybody else have a 4Runner that sounds like a type writer is inside the dashboard when the key is on?

What about the leaking from the front side of the 3rd member?

Trying to figure out what's going on. There is a ridiculous amount of vibration around 25mph and around 55-60. It does go away for most part after applying the brakes and coasting. It seems to not be as pronounced if you drive it like you stole it. But if you try to drive it gingerly the...

I meant 4th gen rear rotors

I never used the parking brake while changing the brakes. The rear rotors did not just pop off on either side though due to the rotors being rusted onto the hubs. I had to pb blaster them several times and use a mini sledge to get them to pop off