Recent content by richhassett

Diy Yea do it all yourself...save some money!

Yea we didn't have anything to jack it up. A hi lift would of done wonders. Did the best we could to dig it out but mud and sand mixed is brutal!

I don't have a welder unfortunately. Body shop estimated 230 for labor.. Found the front crossmember for 260. Pretty expensive for a lesson learned!

Cool.

It was a running start with a tow strap on the single loop being pulled out of sand. Basically high centered with all suspension completely extended.

Thank you. I will call a few shops and see what they can do for me. I would definitely like to get it done soon. Thank you for your help.

Ok great Ill see about jacking it up at that point. I was not sure where the mount points would be for an aftermarket bumper so this helps a lot. Thanks for the input.

I added some green lines to show where it should be. You can see how it connects to the other side with the recovery point being straight. Ill try to take some more pics at a better angle when i get the chance.

Sooooo I decided to get stuck this last weekend and got yanked out. unfortunately being new to this whole thing...learned to use BOTH recovery points. Does anyone have any suggestions on repair? It is bent below the weld points so I assume I could get it chopped. My plan is to eventually get a...

Is it all the time? I have an issue like this as well.. When I'm braked and in gear I hear it go off and on.

Illegal to copy military ID Just a heads up, it is ILLEGAL to copy and send an ID. There are other means of verifying military status. Using their LES as well as using a registered military email address. Source: The photocopying of a military identification card or a common access card is...

I am looking at the above and the total price is coming out nearly 400$. 2.5 bundles of package 1 for the matts? And also same with the ensolite. I noticed you had said it costs 300$-350$ but it seems I would be paying well over that. How many BXT II mats total did you buy? The bundle is about...