Recent content by Ruedger556

So today I went out to grab something from my 4runner and rolled the back window down via the key, well when i went to roll it back up it would only go halfway then just stop. I can roll it down and back to halfway but that's it. What could be the issue? And anyone have any good tricks for...

Are these still available? I live in sw michigan as well so I could meet up and save on shipping.

Got the holes patched and bedliner on last night. Very happy with how it turned out. It looks alot better in person! I used aluminum duct tape over the holes then used bondo over the top of that so it gave it a harder surface to bond to instead of the tape, Turned out really well.

Yea I wasnt a fan of the plastic flares at all. Gonna bed line tomorrow.

Yea I tossed them. The back clip brackets all were broken.

That looks like its gonna be a pain!! Guess I know what I'm gonna be doing soon.

So I just bought my first 4runner I'm not a fan of the fender flares and the door cladding so I decided to remove them. I'm gonna patch all the holes then put bedliner on the lower half. Should look good with the dark green. The last photo is the before. There was so much mud and debris...

Awesome. I'm hoping I can find a way to change it out without pulling the whole compressor out.

Is it ok to drove without the a/c belt on till I can get it fixed?

Took the belts off one by one. Looks like it's my a/c pulley. Not my idler pulley!

I'm gonna remove the belts today and see what happens

No it doesnt get worse with the ac on.

Heres the list of what he did to it.

Timing belt and all that was done at 182k vehicle is now at 212k the previous owner said it's always done it since hes owned it. I'm gonna take off all the belts again tonight and try everything.

So I bought my first yota a couple weeks ago and noticed that it has a strange grinding noise from the from drive belts/pulleys. It's not there when I first fire the engine up. But when it gets warmed up it's pretty loud. I just replaced the drove belts and idler pulley last night in Hope's...