Recent content by Salty4Life

So my 99 supercharged 4Runners ac stared blowing warm while driving. At idle it blows cold. When RPMs increase it blows hot again. What pressures should I be looking for on the ac gauges?

Well I figured I should keep this thread alive. I now own this runner. This will be my 3rd 3rd gen 4runner. I guess I’m just obsessed with these things. Got it registered today and did a little driving around town to get a feel. The gears plus the SC is a night and day difference from my current...

Cleaning the MAF sensors and re checking all the vacuum lines fixed it. Thanks yall

Cleaned the MAF sensors, and checked all vacuum lines. I disconnected the battery to clear the codes. Drove around today and the lights haven’t come back on. It’s just strange that the MAF sensor can throw that many codes

I have a 98 4Runner. Recently changed o2 sensor, upstream abs downstream. I drove the car about 20 miles today and the check engine light turn on. The codes from the scanner are. P0171 sysytem to lean bank 1 A/Fs or ho2s contaminated deteriorated or system failed, air leaks after MAF sensors or...

I’ll take 3

I swapped tried two different abs ecu. One from a 2000 with the same part number and one I found on eBay for $25 that was supposed to be from a 98.

I don’t have anything on my t case. I picked up a speed sensor from autozone and I can’t find anything on this car that it would go to. Swapping abs ecu didn’t fix it. Cleaning all wheel sensors didn’t fix it. What’s next?

I swapped the ABS ecu with one from a 2000 automatic. At fist the abs light was off but the check engine light was still on and Speedo non functional. Second time starting the car the abs light was back on. This time with codes 31 32 33 34 and 41. I want to swap the vss next. Would it be the...

I had the third light out. I’ve replaced it, abs light is still on. All lights function normally with the right turn signal blinking fast. Do you have a picture of the abs ecu?

I have a 98 T4R manual 4x4 with abs codes 31 33 34 49 and a check engine light that returned code p0500. Speedometer it intermittently not working. Attached are pictures of the scanner. I’ve already cleaned the three wheel speed sensors and still nothing. Please advise next steps.

So the 2000 is a j shift auto with a saggy rear end. The 98 has a 2-3 inch lift. Wouldn’t the extra length help in this application?

I’m looking to swap out the drive shaft in a 98 5speed 4x4. I have access to a 2000 auto 4x4 I can pull the shaft out of. Are these compatible? The 2000 seem to have an aftermarket driveshaft that could be serviced in the future if needed. Both flanges line up.

So I tried to follow along with the video to install the new seals, but they got hung up on the hole for the ABS sensor. I also had to hammer the seals in from the start, and in the video it looks as if he pushes the seal in by hand past the ABS hole and only does a little hammering past the hole.

Sorry that was supposed to be 31,32, and 33. I fixed it.