Recent content by Scott E.

04 V6 SR5 4WD - 270Kmi

To me, it looked like the interior plate was just a baffle to keep liquid oil from getting to the PCV valve. The gasket on mine was similar, but I didn't see the need to reseal it. YMMV. Scott

Would a set of 2018 TRD takeoffs fit my 2013 SR5?

OK, I have done some searching on here and I haven't found anything that really fits my situation. I bought my wife a new to us 2013 SR5 and I need to add some running boards to help her get in and out. It looks like there is sort of a split in fitments between the 2013 and 2014, and not all...

What color and condition are the weathertech's? shipped to 46011?

Ok, a quick followup. I did a continuity check on the cable and found one of the wires was open. I purchased a new cable and installed it yesterday. The ABS light did reset itself after driving a couple of hundred feet. I did have to do a zero point calibration to reset the vsc and traction...

I have fixed mine with the window up/down before. However, the last time the wiper didn't work, I had to replace the wiper motor. In my case the wiper wouldn't work, and I couldn't roll down the window, run the rear defogger or washer. '04 SR5 253,000mi Scott

Bump

My VSC and ABS lights came on my 04 SR5 V6 4WD the other day. I assumed that it was related to my oxygen sensors, like normal. I attempted to do a zero point calibration, but couldn't get past the clearing of the calibration. Once I did the 4 quick pulses on the signal line, the ABS light...

Took my hubs and new bearings to a friend of mine's machine shop and pressed them in myself. Much cheaper than buying the kit, but it did take time

Had the same problem with the vsc light and did the zero point calibration. I ended up replacing the oxygen sensors and the vsc light problem went away

I still have them PM me with your zip and I can give you an idea on the shipping charges.

yes, they are still available. Shipping looks like about $12to 20143. Sorry it took so long to reply, I have the notifications sent to an email account I don't check very often, especially since I started the thread several months back.

OK, here's an update. I just finished installing my two new CVJ Axles and new Koyo front bearings. All in all it went smoothly, with a few minor hiccups. Like shearing off two mounting bolts for the skidplate while removing them. Pressing the bearings was not that big of a deal, if you...

pretty much had to have come from inside your bearings. not much else around there to throw grease, except a leaky cv boot. I do not purchase anything from Autozone anymore. I buy from someplace that I can get a name brand, not the house brand.