Recent content by sharky

Approximately 15k highway miles. 9/32 tread depth P-rated, size 265/70/17 Local pick up, cash only Located in Mountain View

OEM roof rack. Came off a 2011 Limited. Good condition. Comes with all hardware and end caps. Local pickup only. $50.

OEM roof rack that came off a 2011 Limited. Comes with rails, cross bars, end caps, and mounting hardware. Not interested in trading for anything. Located near Mountain View, CA.

Installed rock sliders and no longer need my rocker panels or rear fenders. Came off a 2011 Limited. Condition is great, has typical wear and tear. Item is in the Bay Area, specifically Mountain View. Will not ship. Asking $200. Open to offers. It's been sitting in my garage for...

Still room to get in on this?

Just received my Victory 4x4 roof rack and trying to understand what the best way is to seal the mounting holes to prevent water intrusion. Their instructions were to use a generous amount of black RTV around and in the factory mounting holes. I was planning on going this route, but wondered...

Apologies for reviving the thread but thought it made sense to piggyback off one than start a new one. Probably a dumb question, but I've never done wiring before. I have a pair of Squadron Sports (that I've set up as ditch lights), the Baja Designs harness with relay, and a Toyota factory...

Did the 2014 Trail trim mod on my truck and replaced the rocker panel molding and the rear door molding so no longer need it. It's metallic grey. Came off my 2011 Limited. Pick it up tomorrow morning/afternoon or anytime next week. I work in Santa Clara so prefer meeting up around there.

1. You can cut your rockers - a few members on here have done it. 2. Check out this mod. It's a pricey mod if you buy the parts from the dealer, but if you're lucky, you can get the rocker trim pieces from a junkyard for cheap. 3. Buy the Shrockworks trim piece that codyHTX provided.

For those who decided to replace the door flares, did you have to buy the weatherstripping and extra clips or were you able to reuse the ones from the existing part?

Sorry to revise this thread. Just got my C4 sliders and looking for any recommendations on Powder Coaters in the South Bay. Just moved here from LA. This is my first time getting powder coating on anything. How do you get quotes? I called a couple of shops but they told me to bring them in...

I have a 2011 Limited. The only issue I have is that the driver side power window controls don't always work and that the hill-start assist is finicky. But yes, if the passenger airbag hasn't been replaced, get that done ASAP.

Were you out of alignment by a lot? The guy who did my install said I didn't really need to do an alignment because it was only a 1" lift and when he test drove it, it was straight and steady.

Paid! Thanks again!

I assume you'd need a full length rack to run a RTT? Never had a RTT before but highly considering one now.