Recent content by sjm1027

I just went to the site, looks pretty interesting I must say. So if I used a F-103N in a 2005 4Runner will it clear the little door on the skid plate? Or would I have to drill a nipple hole :biggrin2: Has anyone out there used one of these drains? Thanks Steve

Oil change was 14mm for the oil drain and 5.5 quarts . The only pain was the tube under the oil catch in the filter area. That setup sucks... we need to design something better Maintenence light has been reset! Thanks everyone Steve:D

Anyone know how to do this on a 2005 4Runner? Steve

So is the oil plug under this plastic door in the skid plate. The plug you can feel about 1/2 inch in? I think someone said 14mm? I think I am all set. Looks like Toyota won't be charging me $44.00 any more. Thanks

Nice write up, Thanks for the help, very clear... Do you know where I can find where these 6 fittings are? Nothing in the manual. Thanks again Steve

I couldn't get right under it I could only feel one plug very close to the plastic door. Maybe someone can help us

Well I sure hope so... There is nothing else there, why did you see anything else in that area?

Great, yes I have a 6 cyl. So do you ever have a problem with oil getting mehind the skid plate? The oil filter has this tube (Short) and a plug in it. I was thinking of hanging a cup there while I changed the filter. Looks like it could be a small pain. Thanks Steve

I looked under the vehicle and found an oval coutout around 4"x8" oval. and the 4x8 hole was covered by a plastic cover you just pop off. I want to change the oil but I have been reading that most of you drop the skid plate to do this. Why is that? Has anyone had trouble, is this oval hole not...

thanks

I am looking for a rubber mat. Not the mat you unroll and it rolls partually back up. I want a nice rubber flexible. Anyine have any ideas? I don't have that shelf

Drive safe Let us know when your back!

Where did you get the bar in the front? What is it called? I like it!

Already says 1955 I wrote to a few, lets see what happens Thanks

The forum thinks I am under 13 when I am 50... How can I change this?