Recent content by skinnyrick

hey guys i took the timing belt cover off and it has jumped a hole tooth maybe two so i am replacing the belt and i hope that was the problem, the marks are not lined up and that is probably why i have a big loss of power unless there is something else?? thanks skinny

hey guys please help my 97 4runner won,t even hardly pull out of the driveway it starts ok runs ok trans fluid is clean no burn smell the air filter was dirty so i tried accellerating with it off no change when in any gear and you give it gas it will bawg down like it is not gettiny any fuel...

thanks

can not get your emails hey guys i have tried to get your emails and it kicks me back to the forum thread if anyone can tell me what i am doing wrong please help and tim i did get your # you other guys please try to email me again thanks everyone skinny:confused:

jpless in dc hey i tried to send you a pm don't know if it went through so all you guys can email me at [email protected]

hey tim email me and we will talk i just put it on the forum and all i am asking for it is a fair price and yes i will help ypu bolt it on so you guys get hold of me and talk the gaurd cost me around 800.00 and i will sell it cheap to fellow forum guys remember this is all polished stainless...

i sent you a pm let me know if you get it if you did not get the pm let me know .send me your email and we will talk the grillgaurd looks great you can ride to frederick and see it thanks

better photo i have more i can email

!!96-98 4runner ~Manik Polished Stainless Steel Grill Gaurd ( pictures below!!!) hey guys i have a manik front grillgaurd#923450SP for sale it fits 96-98 4runners according to manik i had it on a 97SR5 4runner,will sale for around 250.00 or best offer . it can be shipped but probably $$$ i live...

a big thank you to Lance the man!!!!!! hey lance ,i just want to say thank you so much for the wiring diagram all i have to do now is get some time to hook my lights up the right way . i have searched for weeks and sent out about a hundred emails and post and no one had a answer and that is why...

lights hey lance this is rick ,thanks for the reply i did use a tester on the highbeam light sockets and both sides where hot even when the lights are on low beam so i guess these must turn on with the ground ? that is why i am confussed because the highbeam fuses stay hot also . i need someone...

pictures i will try to get some photos all of the manik stuff looks great and the piaa driving lights are the icing on the cake.rick

hey guys i just installed a set of piaa 6252 driving lights on my o4runner ,install went well the problem is i tapped the power switch wire to the highbeam 10 amp fuse and it stays hot even when i switch to lowbeam .does anyone know on this model 04 4runner where i can tap into so the lights...