Recent content by snuffleupagus

Another data point, no rubbing lock to lock on the JBA UCA's. Haven't taken it out and aired down\wheeled it hard yet since throwing them on, but I don't think there will be enough deflection to make contact anywhere. Wheels: FN Fx Pros - 17x8, 0 offset, 4.5 BS Tires: Nitto TerraGrappler G2...

It should come off as one unit. Lift up the rubber weather stripping and you'll see how they're held in underneath. They just slide off the posts they're attached to (like an MLOK or Keymod slot if you're familiar with those). There's one up near the windshield that's pretty tight on mine and...

Normal if you have a non-Pro with Pro wheels on it. The bumper on the Pro's actually gets trimmed at the port (or used to at least, not sure if they're done at the factory now), to account for the offset of the TRD Pro wheels. Without the trim, they'll rub even on stock'ish tire sizes. TRD Pro...

I was in the same boat awhile ago...tired of lugging my Canon 6D and lenses around while traveling. I grabbed a a6300 off eBay just to try out, and loved it so much I bought an a6500. Haven't touched the 6D since. It's a world of difference in size\weight to travel with vs the old Canon setup. I...

Perfect, that's what I was lookin for! Thanks!

Throwing on some Bilstein 6112s here soon...Only looking for ~2 in of lift in the front. Anyone have any experience with these and a moderate amount of extra load on the front end? AGM Battery +35lbs Air Comp\Mount +15 lbs LoPro Bumper\Winch +130 lbs Skids +100 lbs Sliders +90 lbs With all...

Following...What cell chemistry are you planning on using there? Guessing some Li-ion flavor by the voltage. I've been toying around with doing a similar setup, but likely with 4 of the larger prismatic cells (20-60AH) in LiFePO4.

I'm on board! snuffleupagus , TRD Off Road

PM sent

http://www.toyota-4runner.org/5th-gen-t4rs/156502-things-you-did-not-know-about-your-4runner-20.html#post2791697

http://www.toyota-4runner.org/5th-gen-t4rs/245542-calling-all-kings-informational-survey.html

I went with a mix. Shrockworks steel for the engine\trans\transfer, and AL for the gas tank. There's only a 32lb difference between the RCI AL skids and Shrockworks steel for the front three, and it's low slung weight that keeps the center of gravity low'ish. The size of the gas tank skid makes...

As an FYI for folks looking to do the swap, there's a couple units left floating around on eBay for <$70, get em while they're hot! I'm ready to go preemptively take my dash apart in preparation, hah....not having that display has always irked me.

Totally in for a harness here also, TRD Off-Road trim!

I can probably write a script to purge those users programatically for someone with forum mod rights if anyone is interested...sort of a hack job to an issue that should be fixed in other ways though.