Recent content by stunt2

It IS possible to not to have error codes. I had same exact issues and it turned out, that front speed sensors were rised from seating surface, due to knuckle rust and caused inconsisted readings and TRAC/VSC malfunction. They were also full of rust and dirt from inside. Cleaned everyting...

No, I have not. But they would be still no go. Seems I need newer style pads and adjusters

Thanks for the input, but these are the ones that did not fit my setup

Hi all. When replacing rear shoes, I found out that my 2000 SR5 doesn't have self adjusters. Got them from the scrapyard from same year model, test fited but seems they are different. The arm doesn't reach to the starwheel. Tried to teverse the starwheel mechanism, but then it doen't align...

How is the fan wired ? What gives the signal to it, to turn on/off ?

:cheers:

Hi all. Need the sizes of 3rd gen tow hitch cross bar, width and height. That are marked in picture. I tknow that there were variations between them, but every info would be handy. Just state, wether the sizes are from welded, or flipable one. Thanks in advance

If you 'have 4th gen and know very little about 3rd gens', no need to go off topic, 4th gen section is a little bit upper, where you might be more useful :wave:

It's 3rd gen section dude. Which other car should I talk here about ? And it is 3.4, if you couln't guess by part number I stated above

Wanted to buy 90916-03075 thermostat but the shop guy insisted that it was no more available widely and Toyota changed that part number to 90916-03136. Checked it visually, same dimensions, same 82c stamped on it but don't know anything about flow calibration, bypass behavior etc. Haven't bought...

Yes, dirty ring or dirty sensor tip can cause this isuue. Also not fully seated sensor

That video is about 4-th gen You mean, it worked for 3-rd gen too ?

With the ignition on I short E1 and Ts terminals four times. Manual says - " Check that the VSC TRAC warning light is lit indicating the recorded zero point is erased. Turn the ignition off." My car: ABS starts blinking. VSC TRAC is on for a couple of seconds and then it starts blinking too with...

Is the blend door the one that is pictured in my firs post ?

I've re replaced leaky heater core on my 2000 sr5 and after assembly the heater is not blowing hot. The valve on the firewall works when turning the knob from cold to hot. Both heater inlet hoses are hot. Rear heater blows hot. But not getting anything in front... The actuator near the...