Recent content by sunpunkT4R

Part number Toyota gave me is 00014-S0260. I'm still working on making sure security is arming/disarming correctly but the fob def works the door locks. Below is the link to a site with info on these security systems and a link to the part. On the jjguy site is a link to PDF manual with...

It's a '97 Limited

I just had Toyota dealer check original specs with the VIN. Maybe this info will help someone else as well. According to dealer: before being sold for the first time, the truck went to a distributor called Gulf States Toyota here in TX. They installed what is called "Security System Plus" (brand...

Actually, no, I'm not 100% sure this isn't aftermarket. It was in the truck when we got it a few years back. I'm fairly certain it isn't the VIP system as there is no VIP sticker on the windows. There is however a sticker that says PERMAVIN Security. I also don't see anything in the user's...

I ordered a key fob but can't seem to get it programmed (no surprise). Watched several vids and read instructions posted on different sites. Most seem to refer to a reset button on the main module typically under one of the front seats. I finally found what I believe is the main module. Not...

Thanks all. Late rely but we were able to get it started. Unfortunately, my daughter who was in the truck trying things didn't pay super close attention to what exactly she did that finally worked. She THINKS she pressed the button 3x while simultaneously turning the key either to ON or to ACC...

I have seen those results as well. And no, that's not the sequence I found before. We did try it though, we tried a ton of combinations. Guess we weren't holding our mouths just right :/ Honestly I don't think the magic answer a few years ago was even on T4R, seems like it was buried on some...

We have a '97 Limited 4Runner that has the security system with glowing red push button on dash to left of steering column. We do not have the keyless remote (fob) so we keep the system disengaged and always lock/unlock doors with the key. A few years ago when we got this Runner I changed the...

Yes it did

Forgot to update this. I could never find time to mess with this so I ended up going to a shop. They discovered that the main line going from top of tank to canister was disconnected from canister. We apparently did not get it fully reconnected. Well that sucks! Rough pic attached.

Good luck dude. I still have yet to mess with mine anymore. Life!! Here's a link to another thread I started several months ago about the same (or very similar) issue. Maybe something in there will help as well...

Excellent advice guys! This was my thinking as well, that it's related to something we disconnected & reconnected during fuel pump replacement.

I'm not a tech but I was there to help. We used a floor jack to slowly lower it. First had to remove the protective plate which is beneath the tank. Believe it or not we had to disconnect drive shaft at front end to get to one of the bolts holding this plate on. Then ran the jack up under the...

Sorry I neglected to include this - it's a 2008 v6 4wd. Canister is above spare at back. Sounds like a good idea to go back to the mech and ask about the previous smoke test. Thanks a lot for the input.

I originally posted in another thread "when its not the gas cap". No replies so here we go. I am not a mechanic but I'd like to try to avoid going to a shop if possible. I'm chasing codes 0441 incorrect purge flow, 0455 large leak, & 0456 very small leak. Check engine light, blinking VSC light...