Recent content by T4R-noob

  1. T

    BTF Fabrication Quick Disconnect Sway Bar End Links

    thanks tim for the vid picked these up and this helped clear up the install
  2. T

    Wheel bearing, CV, or diff?

    i say wheel bearing, i had that same noise and ended up being my wheel bearings
  3. T

    Elocker OEM wiring?

    you could always use the lowrange4x4 elocker harness that plugs straight to the e-locker so you dont have to run the e-locker ecu. Ultimate Toyota Electric Locker ELocker Wiring Harness Kit by Low Range Off Road (TDI-ELWH)
  4. T

    Front differential differences

    thank you
  5. T

    Front differential differences

    Any differences in the 2000 front diff vs a 2001. Reason being, i just picked up a 2000 limited e-locker rear end and front diff to match gearings to be swapped in my 2001 sport. Need to know if everything with swap over easily on the front diff. Thank you
  6. T

    4:10 vs 4:30

    i can still get the front diff from the same 4runner i got the rear end from, are all the diffs the same no matter what year?
  7. T

    4:10 vs 4:30

    I recently bought an e-locker rear end from a 2000 limited and wanted to do the swap in my 01 sport(3'' toytec lift with 33'' tires), just wondering what gear ratio i should stick with and if regearing would cost alot to do. I believe my stock gears is 4:10 and the 2000 rear end is 4:30. will...
  8. T

    3rd Gen 4Runner Lift Information and FAQ's

    ome 851 gives the rear 6'' of lift with no extra weight, will adjustable links be necessary for the extra lift (upper/lower links and panhard bar)? :bump:
  9. T

    OME 851 vs. 861

    ome 851 gives 6'' of lift with no extra weight, will i need adjustable links and pan bar for the extra lift beside the obvious longer shocks etc...
  10. T

    WTB 01-02 3rd gen sport skid plate

    bump still looking 2015
  11. T

    Nor_cal51501's build thread

    where you got the drl switch and trac switch from?
  12. T

    ***NEW Toytec "Superflex" rear coils***

    Im looking to get these to replace my 890 since I have a lil lean with the ultimate lift. Were the coilovers pre-set at 3" from you guys when ordered, also will I have enough travel with using the 5125 with the superflex?
  13. T

    5RUNNERZ trac off!

    You should post a write up using this switch, did you have to get the harness to for this switch? How did you connect the wires to the switch was there prongs or small pins
  14. T

    WTB 3rd gen pass rear grab bar

    pass rear grab bar handle (holy shit bar) with bolts TAN please with shipping to 96826
  15. T

    2000 4 runner part out.

    pass rear grab bar handle (holy shit bar) with bolts please shipping to 96826?

Members online

Forum statistics

Threads
278,310
Messages
3,554,079
Members
248,016
Latest member
Advally Service
Back
Top