Recent content by Tinkergnome621

Hmmm this is the one I bought it has several fcc numbers listed.... https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F291272357005....wonder if I should just buy a different one...and these are the instructions I...

Just purchased another t4r :D I now have a 04 to go with my 97. It did not come with key fobs so I purchased some from ebay. Followed the instructions to program them. All went well except the window button triggers the panic signal. Is there something to program it to change it or did I...

ok the pads are in the proper locations and it no longer screams like a banshee due to the dust shield rubbing on the rotor. final problem that i am running into is the abs light is coming on jumping pins on the diagnostic connector it gives the abs code of 32 which should be the drivers front...

hmmm ok well that is kind of what we thought as well but have noticed a lot of noise from the front end area i know stuff takes a little to set in but i did not think they would be making noise like this it almost sounds like the dust shields are hitting the rotors

Well started to get my brakes sorted on my 97 4runner and me and a friend that was helping me got a little carried away during disassembly got the new rotors in and went to put the pads in and cannot figure out which is the inner and which are the outer pads. any advice would be great to...

i have a 97 also and just recently did my lower and uppers the lowers were so bad that they were about to fall out of the sockets and the only tension left in them was from what was left of the rubber boot. The uppers were trashed as well tie rod ends could have been better but no where near as...

Well it is a little late in the build for a build thread but i guess little late is better than not at all. With that said my rig seems a little lacking when compared to the other rigs I have seen on the forums. Think I will keep it fairly stock for now :biggrin2: Any way it is a 97' SR5 2wd I...

Well i have been lurking for a little while and getting a little advice here and there. Picked up a 97' SR5 a few months ago finally figured i should introduce myself and say HI.

mine had a chirping squeaking noise from the drivers area and found out it is the drivers seat bolt the front left one nut actually had broke free from the surrounding area not sure if that is your issue but it was driving me crazy until i found it

Not trying to hijack the thread too much but is there a plumbing option from the throttle body to the maf that would get rid of all the other "OEM" stuff there is not really as much information on it as there was on my first gen pathfinder it had a sticky devoted to just that but any help would...

Changed fron o2 sensor and wiper blades

Hey BiggJerry thanks for the bezel it came in today and it will do perfectly you dont happen to have the little square knobs that go on the ac controls do you

Since it is raining and was bored and unable to actually do what i need to do to my 4Runner and I did not notice a write up on it I changed the led indicator for the RS3000 in about 5 min. You will need Soldering Iron LED "Whatever you want I wanted a Blue one". Voltage normally on a led is...

Ok so no dice ok doing all the other stuff today stupid Florida and your inclement weather but I did pick up my tie-rod ends

Ok a little bit of history/help not knowing the history of the vehicle i started to do the tune-up/PMCS tasks that were suggested and what i thought should be done. new tires/ alignement Hankook Ventus 275/60/15 filled up with 91 octane and a can of seafoam two weeks later air filter, NGK...