Recent content by ToxPath

I used the ghetto fix for the same problem--gorilla tape. Its held for 2 years now.

I am running the Nitto Terra Grappler G2 in size 285-70. Had them installed this fall and am very happy with on-road characteristics, including ride quality, handling, noise, wet pavement. Have not had them in snow yet. Also used them for off-road for a week during hunting trip in Maine and...

PaulDavis- Are you running the LT (e-rated) version of the G2's; or the other version they offer (non-LT)?

I have the same setup, but no spidertrax. Tires are 275 Copper AT3's

What lift are you considering? I had the blistein 5100's (front set at 1.75) and 1 inch rear spacer installed on my TE with KDSS at the Toyota dealer without any problems. They essentially just looked up their price for routine replacement of shocks on all for corners and charged me that...

Wondering if anyone has any feedback on the Nitto G2 285/70R17 tire, specifically the non-E rated. Currently running the Cooper AT3 (275's) on my TE, have about 50,000 miles on them and want to go to a 285. Also looking at the new BFG's but concerned about the weight and ride, E's are...

Is the rubbing only on the inside fender liner?

I had the same problem. I fixed it by using a piece of inner tube rubber (cut square, about the size of credit card). Instead of removing the spoiler, I just pushed up on each corner. That was enough space to slide in the piece of rubber.

Any chance you could post a pic of the culprit areas you identified and fixed with the the electrical tape?

I have a 2012 Trail Edition with the front bilstein shocks set at 1.75, and 275 tires. The dealership struggled with the alignment, and I did have to take it back a second time because it was pulling hard to the right (a toe adjustment issue). The caster is now at 2.9 on the left, and 3.1 on...

Hi I have a 2012 TE with KDSS, tires are 275 Cooper AT3's. Just had the 5100's installed at the dealership. Front set to 1.75 and also added the 1 inch rear spacer from Cornfed. The before and after measurements on height were actually closer to 2 inches in front and 1.25 inches in the back...

Here are two pics. One before the modification and one after, parked in about the same spot. As mentioned above I have 5100's all around with the front set at 1.75 and a 1 inch spacer from Cornfed on the rear. The tires are Cooper AT3, size 275

I just did my 2012 TE with 5100's all around. Front set to 1.75, and on the rears I used a 1 inch spacer from Cornfed. Pretty close to level.

1 Front right tire 2 Front left tire 3 Rear right tire 4 Rear left tire 5 (Optional) Spare tire, depending upon size

The front right turn signal lens assembly gets water inside every time it rains. Noticed a very fine crack on edge of the lens that must be how the water is getting in. Now the bulb is blown from getting wet. My question is, how does one remove the signal assembly? I managed to get the two...