Recent content by TRevsRunner

Picked up 3rd member today... Yayaa $350

Very nice... Will post a few pic after its all together

Your right! Not fast But at least enough so I know I won't die... Haha

Yeah it's really not bad! This is the fastest 3rd gen I've ever driven. So go with the used 3rd member... Right on!

I dunno bought the truck an I guess the rear end had been replaced. Have an issue when locking center diff it binds. Feels as if the front and rear are not working together. Trucks at the dealership right now to diagnose the problem. Theyre saying there is a different gear ratio or the front...

2002 4Runner. My truck originally had 4.10's and I am going to switch it back so that it matches the front ratio. What are all the parts that I need for the rear differential? I can get a whole carrier assemble used for $400. Seems like a lot. Wouldn't I only need the ring gear and pinion and...

I have one for you guys... I own an 02' sport edition and I experience some of the same issues. I can only engage my 4x4 when my truck is in neutral. The center diff locking mechanism will also only engage when in beau trial but does take a little longer. However I don't think that the system is...

Ok so, new KO2's today balanced and aligned, and adjusted down to 25.5" center of hub to top of fender. What you think? Good with that? Also purchased a diff drop lot as much as I don't want to put that on. I still have binding issue at full flex only on the passenger side.

D Farms... Now you got me thinking! I know definitely alignment is out of whack. Tires go on tomorrow, balance and alignment. So Toyota had it for the last couple days doing axle seals and stuff. It is defiantly binding at full droop only on the passenger side. So I can tell I am a little to...

This is where I'm sitting at now

Ok so I got my truck back today. So you said I should be at 25" from the top of the fender to the center of the hub at regular ride height. So looks lik a am a little high! Tell me what should the measurement be at full droop? I'm not working on a lift so finding level ground is sorta of...

Will have to measure it again with the new UBJ,LBJ, Bushing, an CV axle job.

Pic I had from the past will have to measure what the current height is

From the looks of it, it seems like the front is sitting a little higher than the rear. When I first got them installed they said they put the fromt a half inch higher than the rear. They thought it would settle That was before I got the superflex's. The rear initially had 3"spacers before the...

Hey guys, got a question for you all. Something does not feel right! So recently just got everything back together last night Sunday, Nov 1st after doing upper and lower ball joints, replacing all the bushings in the control arms uppers and lowers, also replacing CV axles. CV's are from Napa...